UCOS在AVR上的移植使用Winavr.rar
上传时间： 2013-04-24
上传用户：huxz911
Winavr中自带的延时函数说明 Winavr中自带的延时函数说明
上传时间： 2013-06-14
上传用户：Late_Li
Winavr中文教程
上传时间： 2013-11-07
上传用户：yzy6007
HS12232-9带汉字库LCD模块Winavr C++演示程序
上传时间： 2014-12-07
上传用户：894898248
ucosII2.76在Winavr(20050214版本)下的程序包,用pn打开目录下的工程,运行make all工具即可编译可用,绝对可用. Winavr如用2006版本,需要把文件中包含文件signal.h改为interrupt.h(可能在includes.h中改一处即可)
标签： Winavr 20050214 ucosII 2.76
上传时间： 2015-05-04
上传用户：xinzhch
AVR全系列BOOTLOADER源程序 Winavr GCC编译.
标签： BOOTLOADER Winavr AVR GCC
上传时间： 2014-01-18
上传用户：lijianyu172
基于AVR ATmega32 单片机的DS1820驱动程序 基于Winavr 平台编译
上传时间： 2014-01-20
上传用户：13681659100
his project was built and tested with Winavr-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install Winavr and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (<=32kHz/4) to be able to program it while it is running on that!
标签： the 20060125 project Winavr
上传时间： 2014-10-10
上传用户：yan2267246
he AVRcam source files were built using the Winavr distribution (version 3.3.1 of GCC). I haven t tested other versions of GCC, but they should compile without too much difficulty. The makefile used to build the source is included
标签： distribution version AVRcam Winavr
上传时间： 2014-10-26
上传用户：h886166
C Programming for Microcontrollers : Featuring ATMEL’s AVR Butterfly and the Free Winavr Compiler : Joe Pardue SmileyMicros.com
标签： Microcontrollers Programming Featuring Butterfly
上传时间： 2014-01-01
上传用户：jcljkh
