When the P89LPC90x is in programming mode all pins that are not used for programming are tri-stated. During programming mode the reset pin has a Weak pull-up resistor.
标签： programming tri-stated are When
上传时间： 2015-11-03
上传用户：集美慧
This book has been written to support a practically oriented course in programming language translation for senior undergraduates in Computer Science. More specifically, it is aimed at students who are probably quite competent in the art of imperative programming (for example, in C++, Pascal, or Modula-2), but whose mathematics may be a little Weak students who require only a solid introduction to the subject, so as to provide them with insight into areas of language design and implementation, rather than a deluge of theory which they will probably never use again students who will enjoy fairly extensive case studies of translators for the sorts of languages with which they are most familiar students who need to be made aware of compiler writing tools, and to come to appreciate and know how to use them. It will hopefully also appeal to a certain class of hobbyist who wishes to know more about how translators work.
标签： practically programming oriented language
上传时间： 2013-12-10
上传用户：我干你啊
本系统采用电动机电枢供电回路串接采样电阻的方式来实现对小型直流有刷电动机的转速测量。该系统主要由二阶低通滤波电路,小信号放大电路、单片机测量显示电路、开关稳压电源电路等组成。同时自制电机测速装置,用高频磁环作为载体,用线圈绕制磁环,利用电磁感应原理检测电机运行时的漏磁,将变化的磁场信号转化为磁环上的感应电流。用信号处理单元电路将微弱电信号转化为脉冲信号,送由单片机检测,从而达到准确测量电机的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the induced current on the magnetic ring. The Weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
标签： 直流电动机
上传时间： 2022-03-26
上传用户：
微弱信号检测的目的是从噪声中提取有用信号，或用一些新技术和新方法来提高检测系统输出信号的信噪比。本文简要分析了常用的微弱信号检测理论，对小波变换的微弱信号检测原理进行了进一步的分析。然后提出了微弱信号检测系统的软硬件设计，在阐述了系统的整体设计的基础上，对电路所选芯片的结构和性能进行了简单的介绍，选用了具有14位分辨率的4路并行A/D转换器AD7865作为模数转换器，且选用Xilinx公司的Spartan-3系列FPGA逻辑器件作为控制器，控制整个系统的各功能模块。同时，利用FPGA设计了先入先出存储器，充分利用系统资源，降低了外围电路的复杂度，为电路调试及制板带来了极大的方便，且提升了系统的采集速度和集成度。系统的软件设计采用Verilog HDL语言编程，在Xilinx ISE软件开发平台上完成编译和综合，并选用ModelSim SE 6.0完成了波形仿真。关键词：微弱信号检测；信号调理：FPGA：AD7865；Verilog HDL信息时代需要获取许多有用的信息，多数科学研究及工程应用技术所需的信息都是通过检测的方法来获取的。若被检测的信号非常微弱，就很容易被噪声湮没，那么很难有效的从噪声中检测出有用信号。微弱信号在绝对意义上是指信号本身非常微弱，而在相对意义上是指信号相对于强背景噪声而言的非常微弱，也就是指信噪比极低。人们进行长期的研究工作来检测被噪声所覆盖的微弱信号，分析噪声产生的原因以及规律，且研究被测信号的特点、相关性以及噪声统计特性，从而研究出从背景噪声中检测有用信号的方法。1微弱信号检测（Weak Signal Detection）技术2.3.41主要是提高信号的信噪比，从噪声中检测出有用的微弱信号。对于这些微弱的被测量（如：微振动、微流量、微压力、微温差、弱光、弱磁、小位移、小电容等），大多数都是利用相应的传感器将微弱信号转换为微弱电流或者低电压，再经过放大器将其幅度放大到预期被测量的大小。
标签： 微弱信号检测
上传时间： 2022-06-18
上传用户：canderile
