产品型号：VK2C21A/B/C/D 产品品牌：永嘉微电/VINKA 封装形式：SOP28/24/20/16 产品年份：新年份 联系人：陈先生 联系手机：188& 2466& 2436 （加V） 企鹅号：361& 888& 5898 E-mail：crh_chip@163.com 原厂直销，工程服务，技术支持，价格最具优势！ VK2C21A/B/C/D概述： VK2C21是一个点阵式存储映射的LCD驱动器，可支持最大80点（20SEGx4COM）或者最大128点（16SEGx8COM）的LCD屏。单片机可通过I2C接口配置显示参数和读写显示数据，也可通过指令进入省电模式。其高抗干扰，低功耗的特性适用于水电气表以及工控仪表类产品。 特点： ★ 工作电压 2.4-5.5V ★ 内置32 kHz RC振荡器 ★ 偏置电压（BIAS）可配置为1/3、1/4 ★ COM周期（DUTY）可配置为1/4、1/8 ★ 内置显示RAM为20x4位、16x8位 ★ 帧频可配置为80Hz、160Hz ★ 省电模式（通过关显示和关振荡器进入）��� ★ I2C通信接口 ★ 显示模式20x4、16x8 ★ 3种显示整体闪烁频率 ★ 软件配置LCD显示参数 ★ 读写显示数据地址自动加1 ★ VLCD脚提供LCD驱动电压源（<VDD） ★ 内置16级LCD驱动电压调整电路 ★ 内置上电复位电路(POR) ★ 低功耗、高抗干扰 ★ 此篇产品叙述为功能简介，如需要完整产品PDF资料可以联系陈先生索取！
标签： VK2 2C VK VK2C LCD C21 C22 C23 C24 21
上传时间： 2021-12-02
上传用户：15218646864
产品型号：VK2C23A/B 产品品牌：永嘉微电/VINKA 封装形式：LQFP64/48 产品年份：新年份 联系人：陈先生 联系手机：188& 2466& 2436 （加V） 企鹅号：361& 888& 5898 E-mail：crh_chip@163.com 原厂直销，工程服务，技术支持，价格最具优势！ VK2C23A/B概述： VK2C23A/B是一个点阵式存储映射的LCD驱动器，可支持最大224点（56SEGx4COM）或者最大416点（52SEGx8COM）的LCD屏。单片机可通过I2C接口配置显示参数和读写显示数据，也可通过指令进入省电模式。其高抗干扰，低功耗的特性适用于水电气表以及工控仪表类产品。 特点： ★ 工作电压 2.4-5.5V ★ 内置32 kHz RC振荡器 ★ 偏置电压（BIAS）可配置为1/3、1/4 ★ COM周期（DUTY）可配置为1/4、1/8 ★ 内置显示RAM为56x4位、52x8位 ★ 帧频可配置为80Hz、160Hz ★ 省电模式（通过关显示和关振荡器进入）��� ★ I2C通信接口 ★ 显示模式56x4、52x8 ★ 3种显示整体闪烁频率 ★ 软件配置LCD显示参数 ★ 读写显示数据地址自动加1 ★ VLCD脚提供LCD驱动电压源（<5.5V） ★ 内置16级LCD驱动电压调整电路 ★ 内置上电复位电路(POR) ★ 低功耗、高抗干扰 ★ 此篇产品叙述为功能简介，如需要完整产品PDF资料可以联系陈先生索取！
标签： LCD C23 VK2 2C 23 VK 抗干扰 液晶显示 驱动芯片 选型
上传时间： 2021-12-03
上传用户：15218646864
General Design Specification:1. AC Input Range 180-264Vac, Isolated ac-dc offline, 12LEDS,Output 700mA2. Intelligent wall dimmer detections(Leading-edge dimmer , Trailing-edgedimmer , No-dimmer)3. Multiple dimming control scheme4. Wide dimming range from 1% up to 100%5. No visible flicker6. Resonant control to achieve high efficiency7. High Power Factor, 0.9 without dimmer8. Temperature degrade control to adjust the LED9. Primary-only Sensing eliminates opto-isolator feedback and simplifies design
标签： iw3617
上传时间： 2021-12-03
上传用户：canderile
STM32L053C8T6数据手册Features • Ultra-low-power platform – 1.65 V to 3.6 V power supply – -40 to 125 °C temperature range – 0.27 µA Standby mode (2 wakeup pins) – 0.4 µA Stop mode (16 wakeup lines) – 0.8 µA Stop mode + RTC + 8 KB RAM retention – 139 µA/MHz Run mode at 32 MHz – 3.5 µs wakeup time (from RAM) – 5 µs wakeup time (from Flash) • Core: ARM® 32-bit Cortex®-M0+ with MPU – From 32 kHz up to 32 MHz max. – 0.95 DMIPS/MHz • Reset and supply management – Ultra-safe, low-power BOR (brownout reset) with 5 selectable thresholds – Ultralow power POR/PDR – Programmable voltage detector (PVD) • Clock sources – 1 to 25 MHz crystal oscillator – 32 kHz oscillator for RTC with calibration – High speed internal 16 MHz factory-trimmed RC (+/- 1%) – Internal low-power 37 kHz RC – Internal multispeed low-power 65 kHz to 4.2 MHz RC – PLL for CPU clock • Pre-programmed bootloader – USART, SPI supported • Development support – Serial wire debug supported • Up to 51 fast I/Os (45 I/Os 5V tolerant) • Memories – Up to 64 KB Flash with ECC – 8KB RAM – 2 KB of data EEPROM with ECC – 20-byte backup register
标签： stm32l053c8t6
上传时间： 2022-02-06
上传用户：
The PW5410B is a low noise, constant frequency (1.2MHz) switched capacitor voltage doubler. Itproduces a regulated output voltage from 1.8V to 5V input with up to 100mA of output current. Lowexternal parts count (one flying capacitor and two small bypass capacitors at VIN and VOUT) makethe PW5410B ideally suited for small, battery-powered applications
标签： pw5410
上传时间： 2022-02-11
上传用户：wangshoupeng199
The PW5410A is a low noise, constant frequency (1.2MHz) switched capacitor voltage doubler. Itproduces a regulated output voltage from 2.7V to 5V input with up to 250mA of output current. Lowexternal parts count (one flying capacitor and two small bypass capacitors at VIN and VOUT) makethe PW5410A ideally suited for small, battery-powered applications
标签： pw5410
上传时间： 2022-02-11
上传用户：
The PW4556 series of devices are highly integrated Li-Ion and Li-Pol linear chargers targetedat small capacity battery for portable applications. It is a complete constant-current/ constantvoltage linear charger. No external sense resistor is needed, and no blocking diode is required dueto the internal MOSFET architecture. It can deliver up to 300mA of charge current (using a goodthermal PCB layout) with a final float voltage accuracy of ±1%. The charge voltage is fixed at 4.2V or4.35V, and the charge current can be programmed externally with a single resistor. The chargerfunction has high accuracy current and voltage regulation loops and charge termination
标签： pw4556
上传时间： 2022-02-11
上传用户：1208020161
The PW4554 is a cost-effective, fully integrated high input voltage single-cell Li-ion battery charger.The charger uses a CC/CV charge profile required by Li-ion battery. The charger accepts an inputvoltage up to 24V but is disabled when the input voltage exceeds the OVP threshold, typically 6.8V,to prevent excessive power dissipation. The 24V rating eliminates the over-voltage protection circuitrequired in a low input voltage charger
标签： pw4554
上传时间： 2022-02-11
上传用户：
The PW2606B is a front-end over voltage and over current protection device. It achieves wide inputvoltage range from 2.5VDC to 40VDC. The over voltage threshold can be programmed externally orset to internal default setting. The low resistance of integrated power path nFET switch ensures betterperformance for battery charging system applications. It can deliver up to 1A current to satisfy thebattery supply system. It integrates the over-temperature protection shutdown and auto-recoverycircuit with hysteresis to protect against over current events
标签： pw2606b
上传时间： 2022-02-11
上传用户：
The PW2601 is a charger front-end integrated circuit designed to provide protection to Li-ionbatteries from failures of charging circuitry. The device monitors the input voltage, battery voltageand the charging current to make sure all three parameters are operated in normal range. Thedevice will switch off internal MOSFET to disconnect IN to OUT to protect load when any of inputvoltage, output current exceeds the threshold. The Over temperature protection (OTP) functionmonitors chip temperature to protect the device. The PW2601 also can protect the system’sbattery from being over charged by monitors the battery voltage continuously. The deviceoperates like a linear regulator, maintaining a 5.1V output with input voltages up to the input overvoltage threshold.The PW2601 is available in DFN-2x2-8L package. Standard products are Pb-free and Halogenfree
标签： pw2601
上传时间： 2022-02-11
上传用户：
