虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

UP-SOPC

  • 基于FPGA的PCI接口的设计

    PCI(Peripheral Component Interconnect)局部总线是微型计算机中处理器、存储器与外围控制部件、扩展卡之间的互连接口,由于其速度快、可靠性高、成本低、兼容性好等特点,在各种计算机总线标准占有重要地位,基于PCI标准的接口设计已经成为相关项目开发中的一个重要的选择。    目前,现场可编程门阵列FPGA(Field Programmable Gates)得到了广泛应用。由于其具有规模大,开发过程投资小,可反复编程,且支持软硬件协同设计等特点,因此已逐步成为复杂数字硬件电路设计的首选。    PCI接口的开发有多种方法,主要有两种:一是使用专用接口芯片,二是使用可编程逻辑器件,如FPGA。本论文基于成本和实际需要的考虑,采用第二种方法进行设计。    本论文采用自上而下(Top-To-Down)和模块化的设计方法,使用FPGA和硬件描述语言(VHDL和Verilog HDL)设计了一个PCI接口核,并通过自行设计的试验板对其进行验证。为使设计准确可靠,在具体模块的设计中广泛采用流水线技术和状态机的方法。    论文最终设计完成了一个33M32位的PCI主从接口,并把它作为以NIOSⅡ为核心的SOPC片内外设,与通用计算机成功进行了通讯。    论文对PCI接口进行了功能仿真,仿真结果和PCI协议的要求一致,表明本论文设计正确。把设计下载进FPGA芯片EP2C8Q208C7之后,论文给出了使用SIGNALTAPⅡ观察到的信号实际波形,波形显示PCI接口能够满足本设计中系统的需要。本文最后还给出试验板的具体设计步骤及驱动程序的安装。

    标签: FPGA PCI 接口的设计

    上传时间: 2013-07-28

    上传用户:372825274

  • 74LS48.pdf

    英文描述: BCD-to-Seven-Segment Decoder Driver(Internal Pull-up outputs) 中文描述: BCD码到七段解码器驱动程序(内部上拉输出)

    标签: 74 48 LS

    上传时间: 2013-07-13

    上传用户:cc1015285075

  • 74LS190.pdf

    英文描述: Synchronous Up/Down Decade Counters(single clock line) 中文描述: 同步向上/向下十年计数器(单时钟线)

    标签: 190 74 LS

    上传时间: 2013-06-18

    上传用户:haohaoxuexi

  • LPC1788用户手册LPC178X_7X_Rev3

    LPC178* 177*用户手册 LPC178x/7x 32-bit ARM Cortex-M3 microcontroller; up to 512 kB flash and 96 kB SRAM; USB Device/Host/OTG; Ethernet; LCD; EMC Rev. 3 — 27 December 2011 Objective data sheet

    标签: LPC X_Rev 1788 178

    上传时间: 2013-04-24

    上传用户:胡佳明胡佳明

  • 最重要的是七个从简单到复杂的实验

    最重要的是七个从简单到复杂的实验,包括:基础实验一_FPGA_LED 基础实验二_seg7实验以及仿真 基础实验三_SOPC_LED 基础实验四_Flash烧写 基础实验五_定时器实验 基础实验六_按键以及PIO口中断实验 实验七_网卡使用 ,这些实验室用到了SOPC BUILDER 与NOIS ii ,使用Verilog 编写,有实验板和没有实验板的都可以用来学习。 其次还包括: FPGA开发板各存储器之间的联系、 多处理器文档 、 USB_UART等文档,很好用的文档,您下了相信不会后悔!

    标签: 实验

    上传时间: 2013-08-12

    上传用户:几何公差

  • FPGA学习的入门资料合辑

    这些课件可以作为对FPGA有兴趣的人学习的入门资料,包含EDA的概述、FPGA结构与配置、VHDL语言、QuartusII软件、SOPC和NIosII嵌入式处理器设计、DSP Builder系统设计工具等内容

    标签: FPGA

    上传时间: 2013-08-13

    上传用户:yan2267246

  • 电台维修模拟训练系统设计方法研究

    Methods for designing a maintenance simulation training system for certain kind of radio are introduced. Fault modeling method is used to establish the fault database. The system sets up some typical failures, follow the prompts trainers can locate the fault source and confirm the type to accomplish corresponding fault maintenance training. A training evaluation means is given to examining and evaluating the training performance. The system intuitively and vividly shows the fault maintenance process, it can not only be used in teaching, but also in daily maintenance training to efficiently improve the maintenance operation level. Graphical programming language LabVIEW is used to develop the system platform.

    标签: 电台维修 模拟训练 方法研究 系统设计

    上传时间: 2013-11-19

    上传用户:3294322651

  • 集成化图像控制引擎的研究与实现

    随着半导体技术以及计算机软硬件技术的飞速发展,对于图像的显示和控制技术也呈现出越来越多的方式。文中介绍了一种基于NIOS II软核处理器实现对SD卡驱动与TFT-LCD控制的方法。在设计中利用FPGA的Altera的SOPC Builder定制NIOS II软核处理器及其与显示功能相关的模块来协同从SD卡读取JPEG格式的图片,经过FPGA解码处理显示于TFL-LCD上,并使用触摸控制实现图片的前进、后退、,暂停、自动播放时间控制功能

    标签: 集成化 图像控制 引擎

    上传时间: 2013-11-01

    上传用户:huangld

  • 凌力尔特工业信号链路

    Industrial systems demand semiconductors that are precise, flexibleand reliable. Linear Technology offers a broad line of high performanceanalog ICs that simplify system design with rugged devices featuringparameters fully guaranteed over the -40°C to 85°C temperature range.We back this up with knowledgeable applications support, long productlife cycles and superior on-time delivery.

    标签: 凌力尔特 工业信号 链路

    上传时间: 2013-11-02

    上传用户:xiaodu1124

  • MAX17600数据资料

     The MAX17600–MAX17605 devices are high-speedMOSFET drivers capable of sinking /sourcing 4A peakcurrents. The devices have various inverting and noninvertingpart options that provide greater flexibility incontrolling the MOSFET. The devices have internal logiccircuitry that prevents shoot-through during output-statchanges. The logic inputs are protected against voltagespikes up to +14V, regardless of VDD voltage. Propagationdelay time is minimized and matched between the dualchannels. The devices have very fast switching time,combined with short propagation delays (12ns typ),making them ideal for high-frequency circuits. Thedevices operate from a +4V to +14V single powersupply and typically consume 1mA of supply current.The MAX17600/MAX17601 have standard TTLinput logic levels, while the MAX17603 /MAX17604/MAX17605 have CMOS-like high-noise margin (HNM)input logic levels. The MAX17600/MAX17603 are dualinverting input drivers, the MAX17601/MAX17604 aredual noninverting input drivers, and the MAX17602 /MAX17605 devices have one noninverting and oneinverting input. These devices are provided with enablepins (ENA, ENB) for better control of driver operation.

    标签: 17600 MAX 数据资料

    上传时间: 2013-12-20

    上传用户:zhangxin