this package contains two .c files.One file implements the merge of two int arrays.The other one implements the merge of two linkage array.
标签：
上传时间： 2016-02-26
上传用户：曹云鹏
The preferred technique places the new YAMON in the opposite Flash bank (the Db1200 boards have two Flash banks), and then changes switch S11 to swap the Flash banks in the memory map to allow the other Flash bank to become the boot bank. This technique is the safest and preferred method since it preserves the existing YAMON
标签： the preferred technique opposite
上传时间： 2016-02-27
上传用户：thuyenvinh
We shall revisit the limitations of the two-layer networks of the previous one.
标签： the limitations two-layer networks
上传时间： 2016-02-27
上传用户：shus521
有3种音乐选择演奏,按A\B\C选择音乐,按Q推出程序.
上传时间： 2013-12-24
上传用户：784533221
基于OFDM的无线宽带系统仿真It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
标签： simulator i.e. system-level link-level
上传时间： 2016-03-15
上传用户：xsnjzljj
This project aim was to build wireless software modem for data communication between two computers using an acoustic interface in the voice frequency range (20Hz– 20,000Hz). The transmitting antenna is a speaker (frequency response of: 90Hz – 20,000Hz) and the receiving antenna is a microphone (frequency response of: 100Hz – 16,000Hz). The test files used as information files were text files. This goal was attained both in an incoherent scheme and in a coherent scheme. Build under Matlab code, our modem uses OFDM (orthogonal frequency division multiplexing) modulation, synchronization by LMS sequence, channel estimation (no equalizer) via pilot tones. The symbols are either PSK or ASK for a constellation size of 2 or 4. To optimize the probability of error, these symbols were mapped using Gray mapping. Report
标签： communication computers software wireless
上传时间： 2014-05-29
上传用户：wangdean1101
Aexp8-1.asm 声-光报警程序 * 运行步骤:1.按下一次开关SW3,开始声-光报警,再按下一次则停止 重复上述操作* 2.按下"q"或者"Q",退出
上传时间： 2016-03-18
上传用户：fanboynet
It is about link data structure of q
上传时间： 2016-03-26
上传用户：heart520beat
C++A&Q.chm,对学习vc++6.0会有些帮助
上传时间： 2016-04-07
上传用户：gonuiln
A digital fi‘equeney meter designed with FPGA development software Q-~us 11 is introduced．The 1 Hz—l MHz input measured pulse signals of the digital ii‘equency meter can be used for measuring frequency，period，pulse width and duty ratio，etc．The test results stably display O71 3 seven—segment numeric tubes，and the measuring ranges may be switched over automatically．The measuring error is equal to or less than 0．1％．
标签： development introduced designed software
上传时间： 2016-04-09
上传用户：stewart·
