虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

SystEM-on-chip

  • CN3052A(锂离子电池充电器)

    The CN3052A is a complete constant-current /constant voltage linear charger for single cell Li-ion and Li Polymer rechargeable batteries. The device contains an on-chip power MOSFET and eliminates the need for the external sense resistor and blocking diode.

    标签: 3052A 3052 CN 锂离子电池

    上传时间: 2013-11-10

    上传用户:子虚乌有

  • 基于8098单片机的SPWM变频调速系统

      数字控制的交流调速系统所选用的微处理器、功率器件及产生PWM波的方法是影响交流调速系统性能好坏的直接因素。在介绍了正弦脉宽调制(SPWM)技术的基础上,设计了一种以8098单片机作为控制器,以智能功率模块IPM为开关器件的变频调速系统。通过软件编程,产生正弦脉冲宽度调制波形来控制绝缘栅双极晶体管的导通和关断,从而达到控制异步电动机转速的目的。实验结果表明,该系统可调频率调电压,稳定度高,调速范围宽,具有较强的实用价值   Abstract:   AC variable speed with digital control systems used microprocessors, power devices and generate PWM wave is the direct factors of affecting the performance AC speed regulation system. On the basis of introducing the sinusoidal pulse width modulation (SPWM) technology,this paper designed variable speed system which used 8098 as a controller, intelligent power module IPM as switching device. Through software programming, resulting in sinusoidal pulse width modulation waveform to control the insulated gate bipolar transistor turn on and off, so as to achieve the purpose of speed control of induction motors. Experimental results show that the system can adjust frequency modulation voltage, high stability, wide speed range, has a strong practical value.  

    标签: 8098 SPWM 单片机 变频调速系统

    上传时间: 2013-11-14

    上传用户:ynwbosss

  • H.264高清编解码器的片上系统MG3500

    MG3500SoC是支持H.264高清编解码器的片上系统,内部集成一个嵌入式ARM926处理器,支持高清H.264编解码、MPEG鄄2解码和JPEG编解码。介绍了MG3500SoC的主要性能特点、引脚排列、主要接口功能及在DVR上的应用,以及MG3500SoC及其周围器件的硬件设计,提出了在设计中应注意的问题。 Abstract:  The MG3500SystEM-on-chip(SoC)is high definition(HD)H.264codec,including ARM926-EJ processor,H.264encoder/decoder,MPEG2decoder and JPEG/MJPEG encoder/decoder.The features,pin assignments,interfaces and the typical application of MG3500in DVR are introduced in this paper.The application hardware circuit between the MG3500SoC and peripheral device are given,the questions which the syetem design needs to pay attention are explained.

    标签: 3500 264 MG 编解码器

    上传时间: 2013-11-12

    上传用户:elinuxzj

  • PCF2116系列LCD驱动器芯片简介及封装库

    1 FEATURES· Single chip LCD controller/driver· 1 or 2-line display of up to 24 characters per line, or2 or 4 lines of up to 12 characters per line· 5 ′ 7 character format plus cursor; 5 ′ 8 for kana(Japanese syllabary) and user defined symbols· On-chip:– generation of LCD supply voltage (external supplyalso possible)– generation of intermediate LCD bias voltages– oscillator requires no external components (externalclock also possible)· Display data RAM: 80 characters· Character generator ROM: 240 characters· Character generator RAM: 16 characters· 4 or 8-bit parallel bus or 2-wire I2C-bus interface· CMOS/TTL compatible· 32 row, 60 column outputs· MUX rates 1 : 32 and 1 : 16· Uses common 11 code instruction set· Logic supply voltage range, VDD - VSS: 2.5 to 6 V· Display supply voltage range, VDD - VLCD: 3.5 to 9 V· Low power consumption· I2C-bus address: 011101 SA0.

    标签: 2116 PCF LCD 驱动器芯片

    上传时间: 2013-11-08

    上传用户:laozhanshi111

  • 可编程系统级芯片提供了最大设计的灵活性

    可编程系统级芯片提供了最大设计的灵活性 极端灵活且完全可编程的混合信号SOC 的基本原理是促使赛普拉斯微系统公司(Cypress MicroSystems)推出名为PSoCTM(Programmable SystEM-on-chipTM,可编程系统级芯片)的全新一代器件的动力所在。

    标签: 可编程 系统级芯片

    上传时间: 2013-10-22

    上传用户:playboys0

  • Clocking Options for Stellaris

    The main oscillator allows either a crystal or single-ended input clock signal. Cost-sensitiveapplications typically use an external crystal with the on-chip oscillator circuit since it is the mostcost-effective solution. It is also possible to use the internal oscillator to clock the device after theboot process has completed.

    标签: Stellaris Clocking Options for

    上传时间: 2013-10-14

    上传用户:pol123

  • Emulating a synchronous serial

    The C500 microcontroller family usually provides only one on-chip synchronous serialchannel (SSC). If a second SSC is required, an emulation of the missing interface mayhelp to avoid an external hardware solution with additional electronic components.The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using optimized SW routines with a performance up to 25KBaud in Slave Mode with half duplex transmission and an overhead less than 60% atSAB C513 with 12 MHz. Due to the implementation in C this performance is not the limitof the chip. A pure implementation in assembler will result in a strong reduction of theCPU load and therefore increase the maximum speed of the interface. In addition,microcontrollers like the SAB C505 will speed up the interface by a factor of two becauseof an optimized architecture compared with the SAB C513.Moreover, this solution lays stress on using as few on-chip hardware resources aspossible. A more excessive consumption of those resources will result in a highermaximum speed of the emulated interface.Due to the restricted performance of an 8 bit microcontroller a pin compatible solution isprovided only; the internal register based programming interface is replaced by a set ofsubroutine calls.The attached source files also contain a test shell, which demonstrates how to exchangeinformation between an on-chip HW-SSC and the emulated SW-SSC via 5 external wiresin different operation modes. It is based on the SAB C513 (Siemens 8 bit microcontroller).A table with load measurements is presented to give an indication for the fraction of CPUperformance required by software for emulating the SSC.

    标签: synchronous Emulating serial

    上传时间: 2014-01-31

    上传用户:z1191176801

  • 用C51写的普通拼音输入法源程序代码

    用C51写的普通拼音输入法源程序代码:原作使用了一个二维数组用以查表,我认为这样比较的浪费空间,而且每个字表的索引地址要手工输入,效率不高。所以我用结构体将其改写了一下。就是大家现在看到的这个。  因为代码比较的大,共有6,000多汉字,这样就得要12,000 byte来存放GB内码,所以也是没办法的.编译结果约为3000h,因为大部分是索引表,代码优化几乎无效。    在Keil C里仿真芯片选用的是华邦的W77E58,它有32k ROM, 256B on-chip RAM, 1K on-chip SRAM (用DPTR1指针寻址,相当于有1K的片上xdata)。条件有限,没有上片试验,仿真而已。  打算将其移植到AVR上,但CodeAVRC与IAR EC++在结构体、指针的定义使用上似乎与C51不太一样,现在还未搞定。还希望在这方面有经验的网友能给予指导。 #include<stdio.h> char * py_ime(char *); void main(void){ while(1)    {     char input_string[]="yI";     xdata char chinese_string[255];     sprintf(chinese_string,"%s",py_ime(input_string));    }}

    标签: C51 拼音输入法 代码 源程序

    上传时间: 2013-10-30

    上传用户:cainaifa

  • pk51下载 (8051单片机开发工具)

    PK51是为8051系列单片机所设计的开发工具,支持所有8051系列衍生产品,,支持带扩展存储器和扩展指令集(例如Dallas390/5240/400,Philips 51MX,Analog Devices MicroConverters)的新设备,以及支持很多公司的一流的设备和IP内核,比如Analog Devices, Atmel, Cypress Semiconductor, Dallas Semiconductor, Goal, Hynix, Infineon, Intel, NXP(founded by Philips), OKI, Silicon Labs,SMSC, STMicroeleectronics,Synopsis, TDK, Temic, Texas Instruments,Winbond等。通过PK51专业级开发工具,可以轻松地了解8051的On-chip peripherals与及其它关键特性。    

    标签: 8051 pk 51

    上传时间: 2013-10-09

    上传用户:1109003457

  • XAPP807-封装最小的三态以太网MAC处理引擎

    The Tri-Mode Ethernet MAC (TEMAC) UltraController-II module is a minimal footprint,embedded network processing engine based on the PowerPC™ 405 (PPC405) processor coreand the TEMAC core embedded within a Virtex™-4 FX Platform FPGA. The TEMACUltraController-II module connects to an external PHY through Gigabit Media IndependentInterface (GMII) and Management Data Input/Output (MDIO) interfaces and supports tri-mode(10/100/1000 Mb/s) Ethernet. Software running from the processor cache reads and writesthrough an On-Chip Memory (OCM) interface to two FIFOs that act as buffers between thedifferent clock domains of the PPC405 OCM and the TEMAC.

    标签: XAPP 807 MAC 封装

    上传时间: 2013-10-26

    上传用户:yuzsu