本系统由支路控制器、单元控制器、显示模块、电源模块四大主要部分构成。支路控制器由SCT89C52单片机作为核心器件，辅以光敏电阻检测环境的变化，通过光电传感器检测道路交通状况，在路灯LED外壳内加装光敏电阻以检测路灯是否故障等，实现对系统整体功能控制；单元控制器以STC89C52作为控制核心，实现与支路控制器的通信，控制单元路灯的自动开关灯，控制恒流源输出功率的大小，辅以自制恒流源提供LED路灯电源；显示模块以LCD12864为核心器件，实现各路灯开关灯时间、路灯状态等信息的显示。整个系统功能齐全，精度高，稳定性好，各项指标均满足设计要求，人机界面良好。
上传时间： 2013-12-20
上传用户：weareno2
stc
上传时间： 2013-11-14
上传用户：dysyase
通过设计基于CPLD 的SDRAM 控制器接口，可以在STM系列、ARM系列、STC系列等单片机和DSP等微处理器的外部连接SDRAM，增加系统的存储空间。
上传时间： 2013-11-14
上传用户：feifei0302
The NCV7356 is a physical layer device for a single wire data linkcapable of operating with various Carrier Sense Multiple Accesswith Collision Resolution (CSMA/CR) protocols such as the BoschController Area Network (CAN) version 2.0. This serial data linknetwork is intended for use in applications where high data rate is notrequired and a lower data rate can achieve cost reductions in both thephysical media components and in the microprocessor and/ordedicated logic devices which use the network.The network shall be able to operate in either the normal data ratemode or a high-speed data download mode for assembly line andservice data transfer operations. The high-speed mode is onlyintended to be operational when the bus is attached to an off-boardservice node. This node shall provide temporary bus electrical loadswhich facilitate higher speed operation. Such temporary loads shouldbe removed when not performing download operations.The bit rate for normal communications is typically 33 kbit/s, forhigh-speed transmissions like described above a typical bit rate of83 kbit/s is recommended. The NCV7356 features undervoltagelockout, timeout for faulty blocked input signals, output blankingtime in case of bus ringing and a very low sleep mode current.
上传时间： 2013-10-24
上传用户：s蓝莓汁
You can use the ByteBlasterMV download cable to do the following:
上传时间： 2013-10-10
上传用户：上善若水
解压密码：www.elecfans.com 随着微电子技术的迅速发展以及集成电路规模不断提高，对电路性能的设计 要求越来越严格，这势必对用于大规模集成电路设计的EDA 工具提出越来越高的 要求。自1972 年美国加利福尼亚大学柏克莱分校电机工程和计算机科学系开发 的用于集成电路性能分析的电路模拟程序SPICE（Simulation Program with IC Emphasis）诞生以来，为适应现代微电子工业的发展，各种用于集成电路设计的 电路模拟分析工具不断涌现。HSPICE 是Meta-Software 公司为集成电路设计中 的稳态分析，瞬态分析和频域分析等电路性能的模拟分析而开发的一个商业化通 用电路模拟程序，它在柏克莱的SPICE（1972 年推出），MicroSim公司的PSPICE （1984 年推出）以及其它电路分析软件的基础上，又加入了一些新的功能，经 过不断的改进，目前已被许多公司、大学和研究开发机构广泛应用。HSPICE 可 与许多主要的EDA 设计工具，诸如Candence,Workview 等兼容，能提供许多重要 的针对集成电路性能的电路仿真和设计结果。采用HSPICE 软件可以在直流到高 于100MHz 的微波频率范围内对电路作精确的仿真、分析和优化。在实际应用中， HSPICE能提供关键性的电路模拟和设计方案，并且应用HSPICE进行电路模拟时， 其电路规模仅取决于用户计算机的实际存储器容量。 The HSPICE Integrator Program enables qualified EDA vendors to integrate their products with the de facto standard HSPICE simulator, HSPICE RF simulator, and WaveView Analyzer™. In addition, qualified HSPICE Integrator Program members have access to HSPICE integrator application programming interfaces (APIs). Collaboration between HSPICE Integrator Program members will enable customers to achieve more thorough design verification in a shorter period of time from the improvements offered by inter-company EDA design solutions.
上传时间： 2013-11-10
上传用户：123312
可以烧录STC单片机
上传时间： 2014-12-31
上传用户：cknck
可以烧录STC单片机
上传时间： 2013-11-02
上传用户：libinxny
Xilinx is disclosing this user guide, manual, release note, and/or specification (the "Documentation") to you solely for use in the developmentof designs to operate with Xilinx hardware devices. You may not reproduce, distribute, republish, download, display, post, or transmit theDocumentation in any form or by any means including, but not limited to, electronic, mechanical, photocopying, recording, or otherwise,without the prior written consent of Xilinx. Xilinx expressly disclaims any liability arising out of your use of the Documentation. Xilinx reservesthe right, at its sole discretion, to change the Documentation without notice at any time. Xilinx assumes no obligation to correct any errorscontained in the Documentation, or to advise you of any corrections or updates. Xilinx expressly disclaims any liability in connection withtechnical support or assistance that may be provided to you in connection with the Information.
上传时间： 2013-11-11
上传用户：zwei41
MP3 portable players are the trend in music-listening technology. These players do not includeany mechanical movements, thereby making them ideal for listening to music during any type ofactivity. MP3 is a digital compression technique based on MPEG Layer 3 which stores music ina lot less space than current CD technology. Software is readily available to create MP3 filesfrom an existing CD, and the user can then download these files into a portable MP3 player tobe enjoyed in almost any environment.
上传时间： 2013-11-23
上传用户：nanxia
