虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

SCX

  • 本说明是前面五个源程序:gsz.rar,SCX.rar,grs.rar, mep.rar,txb.rar的详细说明,请管理员大哥不要计入程序个数.

    本说明是前面五个源程序:gsz.rar,SCX.rar,grs.rar, mep.rar,txb.rar的详细说明,请管理员大哥不要计入程序个数.

    标签: gsz grs mep

    上传时间: 2014-01-21

    上传用户:jqy_china

  • PCA9540B 2channel I2C bus mult

    The PCA9540B is a 1-of-2 bidirectional translating multiplexer, controlled via the I2C-bus.The SCL/SDA upstream pair fans out to two SCX/SDx downstream pairs, or channels.Only one SCX/SDx channel is selected at a time, determined by the contents of theprogrammable control register.

    标签: 2channel 9540B 9540 mult

    上传时间: 2014-12-28

    上传用户:nshark

  • PCA9542A 2channel I2C bus mult

    The PCA9542A is a 1-of-2 bidirectional translating multiplexer, controlled via the I2C-bus.The SCL/SDA upstream pair fans out to two SCX/SDx downstream pairs, or channels.Only one SCX/SDx channel is selected at a time, determined by the contents of theprogrammable control register. Two interrupt inputs, INT0 and INT1, one for each of theSCX/SDx downstream pairs, are provided. One interrupt output, INT, which acts as anAND of the two interrupt inputs, is provided.

    标签: 2channel 9542A 9542 mult

    上传时间: 2013-12-07

    上传用户:europa_lin

  • PCA9544A I2C多路复用器

    PCA9544A 是NXP 公司生产的I2C 总线多路复用器,通过该器件可以将一路I2C 总线扩展为4 路I2C 总线。将1 路上行SDA/SCL 通道扩展为4 路下行通道。通过对内部可编程寄存器进行配置,在同一时间可以任意选择一对SCX/SDx 线。器件拥有四路输入中断,INT0到INT3,分别对应着四路下行通道。该器件还有一个输出中断,输出中断的状态由四个输入中断通过“与”逻辑控制。

    标签: 9544A 9544 PCA I2C

    上传时间: 2013-11-17

    上传用户:woshinimiaoye

  • PCA9546A 4 channel I2C bus swi

    The PCA9546A is a quad bidirectional translating switch controlled via the I2C-bus. TheSCL/SDA upstream pair fans out to four downstream pairs, or channels. Any individualSCX/SDx channel or combination of channels can be selected, determined by thecontents of the programmable control register.

    标签: channel 9546A 9546 PCA

    上传时间: 2013-11-16

    上传用户:cc1915

  • PCA9547 8 channel I2C bus mult

    The PCA9547 is an octal bidirectional translating multiplexer controlled by the I2C-bus.The SCL/SDA upstream pair fans out to eight downstream pairs, or channels. Only oneSCX/SDx channel can be selected at a time, determined by the contents of theprogrammable control register. The device powers up with Channel 0 connected, allowingimmediate communication between the master and downstream devices on that channel.

    标签: channel 9547 mult PCA

    上传时间: 2014-12-28

    上传用户:270189020

  • PCA9547D/PW/BS I2C多路复用器和开关

    PCA9547 是一款通过I2C 总线控制的八进制双向转换开关。它的每对SCL/ SDA 上行通道可以扩展为八对下行通道。但在某一时刻,由可编程控制寄存器中的内容来决定只有一路SCX/SDx 被选择。由多路复用器的通门,VDD 管脚可以用来限制PCA9547 通过的最高电压,这使得每一对SCL/SDA 可以使用不同的总线电压,因此1.8V、2.5V 或3.3V 的器件都可以在无其它保护的情况下与5V 的器件进行通信。它的外部上拉电阻将总线拉高至每个通道所要求的电压电平,所有I/O 管脚都可以承受5V 的电压。设备上电时由通道0 连接,并且允许主机和下行设备进行直接的通信

    标签: 9547 PCA I2C BS

    上传时间: 2014-12-28

    上传用户:sunshine1402

  • PCA9548A 8 channel I2C bus swi

    The PCA9548A is an octal bidirectional translating switch controlled via the I2C-bus. TheSCL/SDA upstream pair fans out to eight downstream pairs, or channels. Any individualSCX/SDx channel or combination of channels can be selected, determined by thecontents of the programmable control register.An active LOW reset input allows the PCA9548A to recover from a situation where one ofthe downstream I2C-buses is stuck in a LOW state. Pulling the RESET pin LOW resets theI2C-bus state machine and causes all the channels to be deselected as does the internalPower-on reset function.

    标签: channel 9548A 9548 PCA

    上传时间: 2013-10-13

    上传用户:bakdesec

  • PCA9548AB I2C多路复用器和开关

    PCA9548A 是一款通过I2C 总线控制的八进制双向转换开关。它的每对SCL/ SDA 上行通道可以扩展为八对下行通道,可以通过可编程控制寄存器的内容来选择任意单一的SCX/SDx 通道或者组合通道。由多路复用器的通门,VDD 管脚可以用来限制PCA9547 通过的最高电压,这使得每一对SCL/SDA 都可以使用不同的总线电压,因此1.8V、2.5V 或3.3V的器件可以在无其它保护的情况下与5V 的器件进行通信。它的外部上拉电阻将总线拉高至每个通道所要求的电压电平,所有I/O 管脚都可以承受5V 电压。

    标签: 9548 PCA I2C AB

    上传时间: 2013-10-13

    上传用户:hanli8870

  • PCA954X家庭的I C SMBus多路复用器与开关

    The Philips family of Multiplexers and Switches consists of bi-directional translating switches controlled via the I2C or SMBus to fan out an upstream SCL/SDA pair to 2, 4 or 8 downstream channels of SCX/SDx pairs. The Multiplexers allow only one downstream channel to be selected at a time, while the Switches allow any individual downstream channel or combination of downstream channels to be selected, depending on the content of the programmable control register. Once one or several channels have been selected, the device acts as a wire, allowing the master on the upstream channel to send commands to devices on all the active downstream channels, and devices on the active downstream channels to communicate with each other and the master. External pull-up resistors are used to pull each individual channel up to the desired voltage level. Combined interrupt output and hardware reset input are device options that are featured.

    标签: SMBus 954X PCA 954

    上传时间: 2013-10-11

    上传用户:dianxin61