虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

Radio-Frequency

  • 基于PIC18F1320微控制器的信号采集系统

      便携式信号采集在机器健康诊断系统中有较高的应用价值。机器健康诊断的信号特点是包括低频信号。本文研究是为了实现简易而且低成本的低频便携式信号采集。以Microchip公司单片机PIC18F1320为核心设计信号采集电路,实现了信号的采集和保存。系统采用串行电可擦除芯片24LC32A保存数据,经过有线通信,信号数据由串行口通过MAX232芯片输送到微型计算机接收和保存,最后绘制出信号波形。 微型计算机程序采用Visual Basic编程。研究成功采样频率为3 kHz的复杂信号,证明该方案符合设计要求。   Abstract:   Portable signal acquisition is useful in machine health monitoring systems. The signal characteristics of machine health monitoring includes low frequency signals. The goal of this study is to realize simple, inexpensive and portable low frequency signal sampling. This paper provides the project of signal acquisition system design based on PIC18F1320 microcontroller manufactured by the Microchip Technology Incorporation to achieve signal sampling and storage. The system adopted EEPROM 24LC32A to store the signal data. The microcomputer received data via wired link with the MAX232 IC through the serial port. The microcomputer program, programmed in Visual Basic, received the data, stored it and plotted the signal. The study successfully samples 3kHz complicated signals and thus meets the design requirement.

    标签: F1320 1320 PIC 18F

    上传时间: 2013-11-19

    上传用户:moerwang

  • 基于MSP430F1611单片机的音频信号分析仪设计

      为了使音频信号分析仪小巧可靠,成本低廉,设计了以2片MSP430F1611单片机为核心的系统。该系统将音频信号送入八阶巴特沃兹低通滤波器,对信号进行限幅放大、衰减、电平位移、缓冲,并利用一单片机负责对前级处理后的模拟信号进行采样,将采集得到的音频信号进行4 096点基2的FFT计算,并对信号加窗函数提高分辨率,另一单片机负责对信号的分析及控制显示设备。此设计精确的测量了音频信号的功率谱、周期性、失真度指标,达到较高的频率分辨率,并能将测量结果通过红外遥控器显示在液晶屏上。   Abstract:   o make the audio signal analyzer cheaper, smaller and more reliable, this system sends the audio signal to the eight-order butterworth filter, and then amplifies, attenuates, buffers it in a limiting range, transfers the voltage level of the signal before utilizing two MSP430F1611 MCU to realize the audio analysis. One is charged for sampling and dealing with the processed audio signal collected by the 4096 point radix-2 FFT calculation and imposes the window function to improve the frequency resolution. The other one controls the display and realizes the spectrum, periodicity, power distortion analysis in high resolution which is displayed in the LCD screen through the infrared remote control.

    标签: F1611 1611 430F MSP

    上传时间: 2013-12-11

    上传用户:jasonheung

  • 基于AVR的新型防汽车追尾安全装置设计

    针对目前汽车追尾事件频发问题,提出一种防汽车车前和车后追尾的安全装置设计。该设计以高性能、低功耗的8位AVR微处理器ATmega8L为核心,结合霍尔式车速传感器、激光雷达测距装置和MMA7260QT加速度传感器,能够兼顾车前和车后,摒弃以往设计中只考虑车前或车后单一性缺点,尤其适用于高速、夜晚或新手行车。 Abstract:  Aiming at the high frequency of vehicle rear-end collision,a safe device design of anti-vehicle rear-end collision is presented.In the design,the high-performance,low-power8-bit AVR microprocessor ATmega8L is utilized as a core combined with Hall-type speed sensor,laser-radar ranging devices and the acceleration sensor MMA7260QT.The design considers both the front and back of a car,and overcomes the drawbacks of former designs in which only the front or the back of the car is considered,so it is especially suitable for high-speed,night or the beginner’s driving.

    标签: AVR 汽车追尾 装置

    上传时间: 2013-10-14

    上传用户:GavinNeko

  • 基于单片机89S52的多功能计数器设计

    该系统由单片机89S52控制模块,程控宽带放大模块,整形模块,FPGA内频率、相位差测量模块等构成,采用等精度测频法测出频率和周期,可测量有效值为0.01~5V,频率范围1Hz~20MHz信号的频率、周期信号,精度高达10-6。采用计数法测量相位差,该系统可测量有效值0.5~5V,频率10Hz~100kHz信号的相位差,精度为1°。系统功能由按键控制,测量结果实时显示,人机界面友好。 Abstract:  The system consists of the following functional blocks:89S52microcontroller controlling module,programmable amplifier module,comparator module,frequency and phase difference testing module in the FPGA.The system use the equal accuracy frequency-examining technique it measures frequency and circle of signal which its ranges is from1Hz to20MHz and the amplitude of which its range is from0.01Vrms to5Vrms,precision is up to10-6.Using of count method,the system detects the phase difference of signal,the amplitude of whic its range is from0.5Vrms to5Vrms and the frequency of which its ranges is from10Hz to100kHz,precision is up to1°,The system functions is controlled by certain keys,measurement results are displayed in real-time and it is friendly interface.

    标签: 89S52 单片机 多功能 计数器

    上传时间: 2013-11-04

    上传用户:CHINA526

  • 基于单片机和FPGA的多功能计数器的设计

    以89S52单片机和EP1C6Q240C8型FPGA为控制核心的多功能计数器,是由峰值检波、A/D转换、程控放大、比较整形、移相网络部分组成,可实现测量正弦信号的频率、周期和相位差的功能。多功能计数器采用等精度的测量方法,可实现频率为1Hz~10MHz、幅度为0.01~5Vrms的正弦信号的精确测频,以及频率为10Hz~100kHz、幅度为0.5~5Vrms的正弦信号精确测相。液晶显示器能够实时显示当前信号的频率、周期和相位差。该多功能计数器精度高,界面友好,实用性强。 Abstract:  A multi-function counter,which uses89S52MCU and EP1C6Q240C8FPGA as a control core,consists of peak detector,A/D conversion,program-controlled amplification,compared shaping and phase-shifting network part.The counter measures the frequency,period and phase of sinusoidal signal.With the equal precision method,the multi-function counter achieves the precise frequency measurement of the sinusoidal signal which its frequency is from1Hz to10MHz,its amplitude is from0.01Vrms to5Vrms,as well as the accurate phase measurement of the sinusoidal signal which its frequency is from10Hz to100kHz,its amplitude is from0.5Vrms to5Vrms.The LCD monitor real-time displays the frequency,period and phase difference of current signal.The multi-function counter features high precision,friendly interface,and strong practical.

    标签: FPGA 单片机 多功能 计数器

    上传时间: 2013-11-15

    上传用户:gy592333

  • 基于ATmega16的标记机控制系统

    介绍了当前普通标记机控制系统现状及其存在缺点,给出气动标记机及相频修正PWM模式的工作原理。采用ATmega16单片机和USB转换RS232接口器件CH341T实现驱动控制系统与PC的实时通讯,标记控制系统可升级到USB接口。采用基于ATmega16的相频修正PWM替换555振荡电路产生的PWM,可直接通过软件调整PWM信号。使用达林顿三极管TIP122替代直流继电器驱动高频电磁阀,使得电磁阀驱动电路简单,成本低廉。该控制系统已成功应用于气动标记机。 Abstract:  In this paper,the actuality and demerit of the common gas marking machine control systems are described.The operation principle of the gas marking machine and the phase and frequency correct PWM of ATmega16is introduced.The real-time communication between the driving control system and PC by CH341T which its function is translated USB to RS232is realized,the control systems is updated grade to USB interface.The PWM signal can be adjustable by software for the555surge circuit was substituted by the phase and frequency.The high frequency electromagnetic value’s driving circuit by DC relay is replaced by TIP122,therefore,the circuit is become simple and the cost cheap.The control systems has been widely used in gas marking machine.

    标签: ATmega 16 标记 控制系统

    上传时间: 2013-10-18

    上传用户:1427796291

  • MSP430在频率测量系统中的应用

       介绍一种以MSP430单片机为基础的智能频率测量系统,采用硬件逻辑与软件指令相结合的方式控制闸门,实现0 MHz~10 MHz范围内无档切换的等精度测量。 Abstract:  An intelligent frequency measurement system based on MSP430 singlechip is introduced. The system uses a way that can combine hardware logic and software instructions to contronl the strobe ,and completes the functions of equal precision in the range of 0MHz~10MHz without shifting

    标签: MSP 430 频率测量

    上传时间: 2013-10-28

    上传用户:dbs012280

  • MT8870D DTMF解码芯片

    Features• Complete DTMF Receiver• Low power consumption• Internal gain setting amplifier• Adjustable guard time• Central office quality• Power-down mode• Inhibit mode• Backward compatible withMT8870C/MT8870C-1Applications• Receiver system for British Telecom (BT) orCEPT Spec (MT8870D-1)• Paging systems• Repeater systems/mobile radio• Credit card systems• Remote control• Personal computers• Telephone answering machine

    标签: 8870D 8870 DTMF MT

    上传时间: 2013-11-20

    上传用户:mpquest

  • PCA9534—带中断的低功耗8位I2C和SMBus IO口

    The PCA9534 is a 16-pin CMOS device that provide 8 bits of General Purpose parallel Input/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, 400 kHz clock frequency, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.

    标签: SMBus 9534 PCA I2C

    上传时间: 2013-11-17

    上传用户:vodssv

  • A Single-Chip Pulsoximeter Des

    This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.

    标签: Pulsoximeter Single-Chip Des

    上传时间: 2013-10-27

    上传用户:黑漆漆