In this first part of the book the Vienna Link Level (LL) Simulators are described. The first chapter provides basics of LL simulations, introduces the Most common variables and parameters as well as the transceiver structures that are applied in Long-Term Evolution (LTE) and Long-Term Evolution-Advanced (LTEA). We focus here Mostly on the Downlink (DL) of LTE as Most results reported in later chapters are related to DL transmissions.
标签： LTE-Advanced Simulators Vienna
上传时间： 2020-06-01
上传用户：shancjb
n the first part of this book, we give an introduction to the basic applications of wireless com- munications, as well as the technical problems inherent in this communication paradigm. After a brief history of wireless, Chapter 1 describes the different types of wireless services, and works out their fundamental differences. The subsequent Section 1.3 looks at the same problem from a different angle: what data rates, ranges, etc., occur in practical systems, and especially, what combination of performance measures are demanded (e.g., what data rates need to be transmitted over short distances; what data rates are required over long distances?) Chapter 2 then describes the technical challenges of communicating without wires, putting special emphasis on fading and co-channel interference. Chapter 3 describes the Most elementary problem of designing a wireless system, namely to set up a link budget in either a noise-limited or an interference-limited system. After studying this part of the book, the reader should have an overview of different types of wireless services, and understand the technical challenges involved in each of them. The solutions to those challenges are described in the later parts of this book.
标签： Communications Wireless Edition 2nd
上传时间： 2020-06-01
上传用户：shancjb
Wireless communications, together with its applications and underlying technologies, is among today’s Most active areas of technology development. The very rapid pace of im- provements in both custom and programmable integrated circuits for signal processing ap- plications has led to the justfiable view of advanced signal processing as a key enabler of the aggressively escalating capacity demands of emerging wireless systems. Consequently, there has been a tremendous and very widespread effort on the part of the research community to develop novel signal processing techniques that can fulfill this promise.
标签： Communication Wireless Systems
上传时间： 2020-06-01
上传用户：shancjb
Welcome to the third volume of the book entitled Technologies for the Wireless Future, which is produced by WWRF. The idea is to take the Most important outputs from the working groups and special-interest groups that compose the Forum and bring them together in a series of one-volume surveys. The latest of these will give the reader a good overview of the WWRF approach to analyzing the future of wireless and mobile communications, as well as an insight into the trends themselves and the key technologies that will be deployed.
标签： Wireless Research Forum World
上传时间： 2020-06-01
上传用户：shancjb
Static electricity is the Most ancient form of electricity known to humans. More than 2000 years ago, the Greeks recognized the attraction between certain mate- rials when they were rubbed together; indeed, the word electricity comes from the Greek elektron, which means amber. During the seventeenth and eighteenth centuries, several key experiments were conducted to understand and measure static electricity. But the discovery of electromagnetism and its formidable break- through has rapidly outgrown interest in static electricity. Even today, where the industrial applications of static electricity are not insignificant, they cannot compare with those of electromagnetism and electrodynamics.
标签： Understand Discharge Electro Static
上传时间： 2020-06-05
上传用户：shancjb
Electrostatic discharge (ESD) is one of the Most prevalent threats to the reliability of electronic components. It is an event in which a finite amount of charge is trans- ferred from one object (i.e., human body) to another (i.e., microchip). This process can result in a very high current passing through the microchip within a very short period of time, and, hence, more than 35% of chip damages can be attributed to an ESD-related event. As such, designing on-chip ESD structures to protect integrated circuits against the ESD stresses is a high priority in the semiconductor industry.
标签： Electrostatic Protection Discharge
上传时间： 2020-06-05
上传用户：shancjb
Applications of microelectromechanical systems (MEMS) and microfabrica- tion have spread to different fields of engineering and science in recent years. Perhaps the Most exciting development in the application of MEMS technol- ogy has occurred in the biological and biomedical areas. In addition to key fluidic components, such as microvalves, pumps, and all kinds of novel sensors that can be used for biological and biomedical analysis and mea- surements, many other types of so-called micro total analysis systems (TAS) have been developed.
标签： Applications Technologies Bio-MEMS and
上传时间： 2020-06-06
上传用户：shancjb
Thanks to the advances in micromachining fabrication technologies and significant cost reduction due to mass production, miniature sensors of angular rate, or gyroscopes, found their way into the everyday life of every user of modern gadgets, such as smart phones, tablets or even wristwatches. Often without realising, many of us are carrying in our pockets fully equipped with all necessary sensors complete inertial navigation systems that not so long ago were available only for advanced vehicles in sea, land, air or space. Accelerometers and gyroscopes are found in specifications of any gadget supposed to react to user movements. And one of the Most commonly used type of gyroscopes used to developed these systems is Coriolis vibratory gyroscope (CVG).
标签： Gyroscopes Vibratory Coriolis
上传时间： 2020-06-06
上传用户：shancjb
HIS IS THE THIRD —and Most likely the last—book in the series on information technology for energy managers and web based energy infor- mation and control systems. This book concentrates on web based enterprise energy and building automation systems, and serves as a capstone volume in this series. The thrust here is that the highest level functions of a building and facility automation system are provided by a web based EIS/ECS system that provides energy management, maintenance management, overall facility operational management, and ties in with the enterprise resource management system for the entire facility or the group of facilities being managed. If there were ever to be a fourth volume in this series, it would follow the logical progression of the first three volumes, and would probably be titled Web Based Enterprise Resource Management Systems.
标签： Enterprise Energy Based Web
上传时间： 2020-06-06
上传用户：shancjb
Electricity has been chosen as the Most convenient and useful form of energy, due to its ease of transportation over large distances and easy conversion to other energy forms. The biggest inconvenience with electricity is that it cannot be stored and must be utilized at the moment of generation. The storage of a large amount of electrical energy is usually connected with its conversion to other types of energy, which significantly reduces the efficiency of such processes. The aim of the power system, often treated as the biggest and the Most complex machine ever built, is to deliver uninterruptible electric energy of demanded quality parameters to consumers.
标签： Electromagnetic Interference Conducted
上传时间： 2020-06-07
上传用户：shancjb
