FM1702的例子程序 Chip type : ATmega16L Program type : Application Clock frequency : 7.372800 MHz Memory model : Small External SRAM size : 0 Data Stack size : 256
标签: type Application frequency 7.372800
上传时间: 2016-10-08
上传用户:chfanjiang
以太网物理层接口器件-10/100 Mbps Fast Ethernet Physical Layer TX/FX Single Chip Transceiver
标签: Transceiver Ethernet Physical Single
上传时间: 2016-10-13
上传用户:jackgao
Realtek LCD monitor chip RTD25xx source code
标签: Realtek monitor source chip
上传时间: 2014-01-05
上传用户:rocketrevenge
Action MP3 chip source code
上传时间: 2014-11-26
上传用户:徐孺
The Inter IC bus or I2C bus is a simple bidirectional two wire bus designed primarily for general control and data transfer communication between ICs. Some of the features of the I2C bus are: • Two signal lines, a serial data line (SDA) and a serial clock line (SCL), and ground are required. A 12V supply line (500mA max.) for powering the peripherals often may be present. • Each device connected to the bus is software addressable by a unique address and simple master/ slave relationships exist at all times masters can operate as master-transmitters or as master-receivers. • The I2C bus is a true multi-master bus including collision detection and arbitration to prevent data corruption if two or more masters simultaneously initiate data transfer systems. • Serial, 8-bit oriented, bidirectional data transfers can be made at up to 100 KBit/s in the standard mode or up to 400 KBit/s in the fast mode.
标签: bus bidirectional primarily designed
上传时间: 2013-12-11
上传用户:jeffery
micro chip的电机资料,主要是交流电机 AC Induction Motor Fundamentals
上传时间: 2016-10-28
上传用户:风之骄子
MT+Single+chip+dual+SIM+MT6225+MT6318+MT6188+MT6301+MT6139+MT6601+MT6302图纸
上传时间: 2014-11-09
上传用户:sdq_123
RC500 Mifare Chip for 8051 code
上传时间: 2016-11-10
上传用户:wcl168881111111
A program based in chip TIRIS programmed in assembler. Useful for prototype design of a RFID reader.
标签: programmed assembler prototype program
上传时间: 2013-12-24
上传用户:youke111
Flex chip implementation File: UP2FLEX JTAG jumper settings: down, down, up, up Input: Reset - FLEX_PB1 Input n - FLEX_SW switches 1 to 8 Output: Countdown - two 7-segment LEDs. Done light - decimal point on Digit1. Operation: Setup the binary input n number. Press the Reset switch. See the countdown from n down to 0 on the 7-segment LEDs. Done light lit when program terminates.
标签: down implementation settings UP2FLEX
上传时间: 2014-01-21
上传用户:sclyutian