虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

INTERFERENCE-to-noise

  • gerber-to-protel is a pdf file

    gerber-to-protel is a pdf file ,which is used for convert bmp to pcb.

    标签: gerber-to-protel file is

    上传时间: 2013-09-18

    上传用户:liuxinyu2016

  • 2012TI电子设计大赛——微弱信号检测装置

    微弱信号检测装置 四川理工学院 刘鹏飞、梁天德、曾学明 摘要: 本设计以TI的Launch Pad为核心板,采用锁相放大技术设计并制作了一套微弱信号检测装置,用以检测在强噪声背景下已知频率微弱正弦波信号的幅度值,并在液晶屏上数字显示出所测信号相应的幅度值。实验结果显示其抗干扰能力强,测量精度高。 关键词:强噪声;微弱信号;锁相放大;Launch Pad Abstract: This design is based on the Launch Pad of TI core board, using a lock-in amplifier technique designed and produced a weak signal detection device, to measure the known frequency sine wave signal amplitude values of the weak in the high noise background, and shows the measured signal amplitude of the corresponding value in the liquid crystal screen. Test results showed that it has high accuracy and strong anti-jamming capability. Keywords: weak signal detection; lock-in-amplifier; Launch Pad  1、引言 随着现代科学技术的发展,在科研与生产过程中人们越来越需要从复杂高强度的噪声中检测出有用的微弱信号,因此对微弱信号的检测成为当前科研的热点。微弱信号并不意味着信号幅度小,而是指被噪声淹没的信号,“微弱”也仅是相对于噪声而言的。只有在有效抑制噪声的条件下有选择的放大微弱信号的幅度,才能提取出有用信号。微弱信号检测技术的应用相当广泛,在生物医学、光学、电学、材料科学等相关领域显得愈发重要。 2、方案论证 针对微弱信号的检测的方法有很多,比如滤波法、取样积分器、锁相放大器等。下面就针对这几种方法做一简要说明。 方案一:滤波法。 在大部分的检测仪器中都要用到滤波方法对模拟信号进行一定的处理,例如隔离直流分量,改善信号波形,防止离散化时的波形混叠,克服噪声的不利影响,提高信噪比等。常用的噪声滤波器有:带通、带阻、高通、低通等。但是滤波方法检测信号不能用于信号频谱与噪声频谱重叠的情况,有其局限性。虽然可以对滤波器的通频带进行调节,但其噪声抑制能力有限,同时其准确性与稳定性将大打折扣。

    标签: 2012 TI 电子设计大赛 微弱信号

    上传时间: 2013-11-04

    上传用户:lty6899826

  • D类数字输入放大器的简化系统设计

    Abstract: This application note describes a new generation of digital-input Class D audio amplifiers that achieve high PSRRperformance, comparable to traditional analog Class D amplifiers. More importantly, these digital-input Class D amplifiersprovide additional benefits of reduced power, complexity, noise, and system cost.

    标签: 数字输入放大器 系统设计

    上传时间: 2013-12-20

    上传用户:JIUSHICHEN

  • 提高在噪声环境下的磁卡读写器(MCR)系统

    Abstract: Most magnetic read head data sheets do not fully specify the frequency-dependent components andare often vague when specifying other key parameters. In some cases, the specifications of two very similarheads from two different manufacturers might be quite different in terms of parameters specified and omitted.The limitations in the data sheets make designing an optimum card reading system unnecessarily difficult andtime consuming. This document outlines a strategy to overcome the above shortcomings and offers guidelinesto overcome the noise issues.

    标签: MCR 噪声环境 磁卡读写器

    上传时间: 2013-11-13

    上传用户:dysyase

  • MAX17600数据资料

     The MAX17600–MAX17605 devices are high-speedMOSFET drivers capable of sinking /sourcing 4A peakcurrents. The devices have various inverting and noninvertingpart options that provide greater flexibility incontrolling the MOSFET. The devices have internal logiccircuitry that prevents shoot-through during output-statchanges. The logic inputs are protected against voltagespikes up to +14V, regardless of VDD voltage. Propagationdelay time is minimized and matched between the dualchannels. The devices have very fast switching time,combined with short propagation delays (12ns typ),making them ideal for high-frequency circuits. Thedevices operate from a +4V to +14V single powersupply and typically consume 1mA of supply current.The MAX17600/MAX17601 have standard TTLinput logic levels, while the MAX17603 /MAX17604/MAX17605 have CMOS-like high-noise margin (HNM)input logic levels. The MAX17600/MAX17603 are dualinverting input drivers, the MAX17601/MAX17604 aredual noninverting input drivers, and the MAX17602 /MAX17605 devices have one noninverting and oneinverting input. These devices are provided with enablepins (ENA, ENB) for better control of driver operation.

    标签: 17600 MAX 数据资料

    上传时间: 2013-12-20

    上传用户:zhangxin

  • 双绞线和低通滤波器降低EMI_RFI

    Abstract: Alexander Graham Bell patented twisted pair wires in 1881. We still use them today because they work so well. In addition we have the advantage ofincredible computer power within our world. Circuit simulators and filter design programs are available for little or no cost. We combine the twisted pair and lowpassfilters to produce spectacular rejection of radio frequency interference (RFI) and electromagnetic interference (EMI). We also illustrate use of a precision resistorarray to produce a customizable differential amplifier. The precision resistors set the gain and common mode rejection ratios, while we choose the frequencyresponse.

    标签: EMI_RFI 双绞线 低通滤波器

    上传时间: 2014-11-26

    上传用户:Vici

  • 消除电源旁路滤波噪声

    Abstract: If sensitive analog systems are run from one supply without the sufficient bypassing to eliminate noise,

    标签: 电源旁路 滤波噪声

    上传时间: 2013-11-23

    上传用户:qiulin1010

  • 降低EMI和保持高效率D类放大器在便携式产品中的应用

    Abstract: Class D amplifiers are typically very efficient, making them ideal candidates for portable applications that require longbattery life and low thermal dissipation. However, electromagnetic interference (EMI) is an issue that commonly accompanies theClass D switching topology. Active-emissions limiting reduces radiated emissions and enables "filterless" operation, allowingdesigners to create small, efficient portable applications with low EMI.

    标签: EMI D类放大器 保持 便携式产品

    上传时间: 2013-11-23

    上传用户:哈哈hah

  • Stabilize Your Transimpedance Amplifier

      Abstract: Transimpedance amplifiers (TIAs) are widely used to translate the current output of sensors like photodiode-to-voltagesignals, since several circuits and instruments can only accept voltage input. An operational amplifier with a feedback resistor fromoutput to the inverting input is the most straightforward implementation of such a TIA. However, even this simple TIA circuit requirescareful trade-offs among noise gain, offset voltage, bandwidth, and stability. Clearly stability in a TIA is essential for good, reliableperformance. This application note explains the empirical calculations for assessing stability and then shows how to fine-tune theselection of the feedback phase-compensation capacitor.

    标签: Transimpedance Stabilize Amplifier Your

    上传时间: 2013-11-13

    上传用户:daoyue

  • MAX2691 L2 Band GPS Low-Noise Amplifier

      The MAX2691 low-noise amplifier (LNA) is designed forGPS L2 applications. Designed in Maxim’s advancedSiGe process, the device achieves high gain andlow noise figure while maximizing the input-referred 1dBcompression point and the 3rd-order intercept point. TheMAX2691 provides a high gain of 17.5dB and sub 1dBnoise figure.

    标签: Amplifier Low-Noise 2691 Band

    上传时间: 2014-12-04

    上传用户:zaocan888