从系统硬件设计和软件构成上，介绍一种以AT89C52单片机为核心,通过无线遥控方法实现对预设电话自动拨号报警的智能呼救系统。系统提供了患者在紧急情况下无法使用电话报警时的一种报警手段。由用户预设的多组电话号码作为语音报警对象,预录可长达20 s的语音信号来说明患者所处地点及病情，并通知患者家人。 Abstract: This paper introduces a intelligent alarming system which is realized by wireless remote control system.This system chiefly consists of AT89C51 the system can processor.User can INPUT several groups of telephone number regarded as alarming objects,The system can record some information 20 seconds to tell the site of the patient.And notice the rokonok of the patient.
上传时间： 2013-11-19
上传用户：wd450412225
为降低成本和解决现有膜片钳放大器系统中PC机的干扰问题，研究了一种基于单片机的膜片钳放大器小系统。该系统采用ADI公司生产的ADuC841作为控制核心，并且配置相应的液晶显示模块LCM3202401。模拟电路部分采用高输入阻抗的AD8627实现微电流信号的采集，并由后级电路进行信号的放大和电阻电容的补偿。它具有硬件电路简单、体积小、使用方便的特点。既可以单独作为小系统实现采集和显示，也可以通过红外方式和PC机进行通讯，在PC机上进行信号的处理。 Abstract: In order to reduce cost and resolve the interferential problem with PC in existing patch clamp amplifiers, a small patch clamp amplifier system design based on microcontroller is studied. It adopts a new high performance microconverter ADuC841 by the ADI as the control core in the system, configuring a liquid crystal module LCM3202401. In the analog circuit, AD8627 with high INPUT impedance is used to detect the low current，signal magnification, as well as resistance and capacitance compensation are accomplished by subsequent circuits. It has the advantage of simple hardware circuit design, small volume and convenient operation. It can either be used as an independent system to measure and show signal detected or transmit to PC by infrared ray.
上传时间： 2013-11-06
上传用户：yy_cn
在需要实时大量输入汉字的显示控制处理应用中，利用传统单片机实现显示控制的设计方法是较难实现的。带汉字字库的液晶模块的使用使得小容量ROM单片机的大量汉字信息输入与显示成为可能。提出了针对汉字字库编码的二级索引拼音输入检索方法,介绍了以ST7920作为控制器的带汉字字库的液晶显示模块的接口方法及汉字显示和控制原理，给出了通用计算机键盘在单片机中的串行接口，采用该技术可大大增强单片机的汉字输入功能。为小容量ROM单片机的大批量汉字信息处理提供了一种汉字输入解决方案。 Abstract: It is difficult to realize Chinese characters INPUT method based on the embedded system by using the traditional design method of display control. It is possible to INPUT and display Chinese characters based on the embedded system with the ROM of small content by using the LCD module with Chinese characters.Chinese characters INPUT method of the quadric index recall in allusion to Chinese characters code is brought forward.The interface and the principle of Chinese characters display control based on the LCD module controlled with the ST7920 is introduced too.The serial interface of the computer keyboard in common use and the embedded system is given at the same time. It can enhance the embedded system function of Chinese characters INPUT by using this technology, and provide a kind of Chinese characters INPUT scheme for the embedded system with small capacity ROM.
上传时间： 2013-11-19
上传用户：jhksyghr
The SN65LBC170 and SN75LBC170 aremonolithic integrated circuits designed forbidirectional data communication on multipointbus-transmission lines. Potential applicationsinclude serial or parallel data transmission, cabledperipheral buses with twin axial, ribbon, ortwisted-pair cabling. These devices are suitablefor FAST-20 SCSI and can transmit or receivedata pulses as short as 25 ns, with skew lessthan 3 ns.These devices combine three 3-state differentialline drivers and three differential INPUT linereceivers, all of which operate from a single 5-Vpower supply.The driver differential outputs and the receiverdifferential INPUTs are connected internally to formthree differential INPUT/output (I/O) bus ports thatare designed to offer minimum loading to the buswhenever the driver is disabled or VCC = 0. Theseports feature a wide common-mode voltage rangemaking the device suitable for party-lineapplications over long cable runs.
上传时间： 2013-10-13
上传用户：ytulpx
要搞清楚单片机与PLC的异同，首先得明确什幺是单片机，什幺是PLC。对此，我们简要回顾一下计算机的发展历程也许有帮助，按计算机专家的原始定义，计算机系统由五大部分--即控制单元（CU）、算术运算单元（ALU）、存储器（Memory）、输入设备（INPUT）、输出设备（Output）组成。早期计算机（晶体管的或集成电路的，不包括电子管的）的CU或ALU由一块甚至多块电路板组成，CU和ALU是分离的，随着集成度的提高，CU和ALU合在一块就组成了中央处理单元（CPU）,接着将CPU集成到单块集成电路中就产生MPU或MCU,出现了如Intel4004、8008、8080，8085、8086、8088、Z80等MPU。此后，MPU的发展产生了两条分支，一支往高性能、高速度、大容量方向发展，典型芯片如：Intel80186、286、386、486、586、P2、P3、P4等，速度从4.7MHz到现在的3.2GHz。另一支则往多功能方向发展，将存储器(ROM、PROM、EPROM、EEPROM、FLASHROM、SRAM等)、输入/出接口（Timer/Counter、PWM、ADC/DAC、UART、IIC、SPI、RTC、PCA、FPGA等）全部集成在一块集成电路中而成为SOC。依愚之见，这就是当今广泛应用的单片计算机，简称单片机。这一分支可谓品种繁多，位宽从8位到32位，引脚数从6个到几百个，工作频率从几十KHz到几百MHz,体系结构既有CISC也有RISC,数不胜数。常用的有MCS-51系列、MCS-96系列、PIC系列、AVR系列、ARM7/9系列、TMS320系列、MSP430系列、MOTOROLA众多的单片机等等。
上传时间： 2013-10-16
上传用户：jjj0202
FEATURES400 MSPS internal clock speedIntegrated 10-bit DAC32-bit tuning wordPhase noise ≤ –120 dBc/Hz @ 1 kHz offset (DAC output)Excellent dynamic performance>75 dB SFDR @ 160 MHz (±100 kHz offset) AOUTSerial I/O control1.8 V power supplySoftware and hardware controlled power-down48-lead TQFP/EP packageSupport for 5 V INPUT levels on most digital INPUTsPLL REFCLK multiplier (4× to 20×)Internal oscillator; can be driven by a single crystalPhase modulation capabilityMultichip synchronization
上传时间： 2014-12-04
上传用户：axin881314
The PCA9536 is an 8-pin CMOS device that provides 4 bits of General Purpose parallel INPUT/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上传时间： 2013-10-27
上传用户：w230825hy
The PCA9534 is a 16-pin CMOS device that provide 8 bits of General Purpose parallel INPUT/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, 400 kHz clock frequency, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上传时间： 2013-11-17
上传用户：vodssv
The CAT25128 is a 128−Kb Serial CMOS EEPROM device internally organized as 16Kx8 bits. This features a 64−byte page write buffer and supports the Serial Peripheral Interface (SPI) protocol. The device is enabled through a Chip Select (CS) INPUT. In addition, the required bus signals are clock INPUT (SCK), data INPUT (SI) and data output (SO) lines. The HOLD INPUT may be used to pause any serial communication with the CAT25128 device. The device featuressoftware and hardware write protection, including partial as well as full array protection.
上传时间： 2013-11-15
上传用户：fklinran
The PCA9534 is a 16-pin CMOS device that provide 8 bits of General Purpose parallel INPUT/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, 400 kHz clock frequency, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上传时间： 2013-10-10
上传用户：inwins
