5x7 moving message display
标签： message display moving 5x7
上传时间： 2017-09-18
上传用户：赵云兴
PicBasic program for PIC16F876A for LCD display. Rolling message displaying for attractive look.
标签： for attractive displaying PicBasic
上传时间： 2017-09-18
上传用户：李梦晗
as a message came into prominence with the publication in 1948 of an influential paper by Claude Shannon, "A Mathematical Theory of Communication." This paper provides the foundations of information theory and endows the word information not only with a technical meaning but also a measure. If the sending device is equally likely to send any one of a set of N messages, then the preferred measure of "the information produced when one message is chosen from the set" is the base two logarithm of N (This measure is called self-information). In this paper, Shannon cont
标签： influential publication prominence message
上传时间： 2014-01-21
上传用户：2404
TTCAN协议在CAN协议基础之上，将事件触发机制与实时性更高的时间触发机制相结合，提高了网络实时性，满足对安全性要求苛刻的实时系统以及总线日益增长的信息负载的需求；同时，CAN总线技术的基础为TTCAN总线技术研究奠定了很好的软硬件支持条件。 论文首先介绍了TTCAN协议的通讯原理、软硬件环境的建立和总线网络性能的测试方法。 按照ISO11898－4标准的要求，在自主研发的CAN总线实时仿真系统上结合软件编程能够实现TTCAN协议的时间触发通讯功能，使整个系统成为具有时间触发功能的TTCAN总线通讯网络，得到网络要采用TTCAN协议通讯时各ECU必须具备稳定可靠的本地时钟和相应的时钟同步和计数机制的结论。 结合混合动力电动汽车动力系统对采用TTCAN协议通讯时的网络性能进行了测试和分析，结果表明，TTCAN网络中周期型消息的实时性不受网络中其他消息的影响，时间触发通讯方式和系统矩阵的调度安排在一定程度上减少了总线上消息间的冲突，提高了网络实时性和总线带宽利用率。 对比分析同等条件下TTCAN总线网络和CAN总线网络的性能，TTCAN协议能够保证网络总线在高峰值负载的情况下网络的实时性。 研究了对TTCAN总线网络中time master（时间主节点）和reference message（参考消息）进行故障诊断和容错的方法，通过实验验证了采用冗余的方式能够保证当前时间意义上的主节点和参考消息故障情况下整个网络的性能不受影响，提高故障情况下网络的可靠性。
上传时间： 2013-04-24
上传用户：refent
在航电系统维护过程中，为解决定位故障的效率和降低维修成本等问题，提出了基于ICD（Interface Control Document，接口控制文件）的1553B总线的信息监控系统模型。该系统运用数据采集卡对总线中传输的信号有无失真、偏差等电气特性进行检测，并使用1553B通讯卡通过测控软件LabWindows/CVI编程与ICD数据库的动态链接，实现总线信息的解析和故障的判断。与传统的维护过程相比，这种模型能够从信号的电气特性以及信息的解析等全方位的去检测判断故障的来源，并且能够广泛在其他1553B总线系统内扩展应用。验证表明该监控系统可以对总线信息进行快速有效地监测分析，能满足应用需求。 Abstract: In the process of avionics system maintenance， to solve the problems such as improving the efficiency of fast orientation to troubles and reducing maintenance cost， system of 1553B bus information monitor model based on ICD was proposed. The system observed whether the data which transmitted on the bus appear distortion and deviation by using data acquisition card. And using 1553B communication card programming of the measure software LabWindows/CVI and the dynamic linking of ICD database， message analysis and fault estimation could be realized. Compared with traditional maintenance， this model can all-dimensionally detect and analyze the source of faults from both electrical characteristics of the signal and message analysis， and it can be widely applied in the other 1553B system. Experiment shown that this monitor system can effectively detect and analyze the bus message and can meet the application requirements.
上传时间： 2013-11-23
上传用户：18752787361
首先研究CAN总线和SAE J1939协议，提出一种基于MC9S12HZ256微控制器的总线式汽车数字仪表解决方案。详细介绍SAE J1939协议的报文帧格式及应用层协议中发动机相关参数的定义，以及步进电机及其驱动和车速信号的处理方法。该数字仪表系统硬件平台由微处理器和信号采集和信息处理及显示等模块组成。软件设计部分编程实现了对CAN总线和各传感器数据的读取、处理。该系统能够实时反映车辆工况。 Abstract: In this paper，CAN bus and SAE J1939protocol are researched，and a vehicle digital instrument solution based on MC9S12HZ256MCU is proposed.The message frame format and some engine-related parameters’definition in SAE J1939application layer protocol are introduced in detail.Stepper motor and its driver，the methods of speed signal process-ing are also introduced.The hardware platform of vehicle digital instrument is composed by MCU，signal acquisition mod-ule，and signal processing and displaying module.Data receiving and processing from CAN bus and sensors are accom-plished by programming，and vehicle condition can be reflected in real-time.
上传时间： 2013-10-20
上传用户：huannan88
FeaturesThe following standard features are provided.• Choice of RTOS scheduling policy1. Pre-emptive:Always runs the highest available task. Tasks of identical priorityshare CPU time (fully pre-emptive with round robin time slicing).2. Cooperative:Context switches only occur if a task blocks, or explicitly callstaskYIELD().• Co-routines (light weight tasks that utilise very little RAM).• Message queues• Semaphores [via macros]• Trace visualisation ability (requires more RAM)• Majority of source code common to all supported development tools• Wide range of ports and examples
上传时间： 2013-10-13
上传用户：13162218709
This application note shows how to write an Inter Integrated Circuit bus driver (I²C) for the Philips P90CL301micro-controller.It is not only an example of writing a driver, but it also includes a set of application interface software routines toquickly implement a complete I²C multi-master system application.For specific applications the user will have to make minimal changes in the driver program. Using the drivermeans linking modules to your application software and including a header-file into the application sourceprograms. A small example program of how to use the driver is listed.The driver supports i.a. polled or interrupt driven message handling, slave message transfers and multi-mastersystem applications. Furthermore, it is made suitable for use in conjunction with real time operating systems, likepSOS+.
上传时间： 2013-11-23
上传用户：weixiao99
The fundamental problem of communication is that of reproducing at one point either exactly or approximately a message selected at another point. Frequently the messages have meaning; that is they refer to or are correlated according to some system with certain physical or conceptual entities.
标签： 通信
上传时间： 2013-10-31
上传用户：liuxinyu2016
1 Communication Protocol (Computer as master) The communication protocol describes here allows your computer to access 4096 internal registers (W0000-W4095) and 1024 internal relays (B0000-B1023) in the Workstation.. 1.1 Request Message Format Request message is a command message to be sent from the computer to the Workstation. The data structure of request message is shown below. Note that numbers are always in hexadecimal form and converted into ASCII characters. For example, Workstation unit number 14 will appear in the message as character 0(30h) followed by character E(45h); a BCC of 5Ah will appear in the message as character 5(35h) followed by character A(41h).
上传时间： 2013-10-28
上传用户：cxl274287265
