虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

Graph-Based

  • Robot Vision--Video-based Indoor Exploration with Autonomous and 

    ·关于机器人视觉最新的大作,2005最新出版,文件格式为PDF。目前在Amazon上售价为152美元

    标签: nbsp Exploration Video-based Autonomous

    上传时间: 2013-06-05

    上传用户:sun_pro12580

  • SystemVerilog for Design

    ·SystemVerilog is a rich set of extensions to the IEEE 1364-2001 Verilog Hardware Description Language (Verilog HDL). These extensions address two major aspects of HDL-based design. First, modeling ver

    标签: nbsp SystemVerilog Design for

    上传时间: 2013-07-14

    上传用户:ainimao

  • 该代码是双速率的语音压缩编码(G.723.1)的matlab代码

    ·详细说明:该代码是双速率的语音压缩编码(G.723.1)的matlab代码。能在matlab6.5以上运行-Dual-rate voice compressed encoding(G.723.1) based on MatLab platform. It works on MatLab 6.5 or later versions.

    标签: matlab 723.1 代码 双速

    上传时间: 2013-06-19

    上传用户:121212121212

  • 基于DSP的三相无刷直流电机调速系统的研究

    ·【英文题名】 Research of Speed Regulate System of Three Phase BLDCM Based on DSP 【作者中文名】 刘桂芬; 【导师】 孟庆春; 【学位授予单位】 辽宁工程技术大学; 【学科专业名称】 控制理论与控制工程 【学位年度】 2007 【论文级别】 硕士 【网络出版投稿人】 辽宁工程技术大学 【网络出版投稿时间】 2006-01-02 【

    标签: DSP 三相 无刷直流电机 调速系统

    上传时间: 2013-06-19

    上传用户:leileiq

  • 以CPLD 芯片进行十字路口的交通灯的设计

    摘要:本文主要介绍以CPLD 芯片进行十字路口的交通灯的设计,用CPLD 作为交通灯控制器的主控芯片,采用VHDL\r\n语言编写控制程序,利用CPLD的可重复编程和在动态系统重构的特性,大大地提高了数字系统设计的灵活性和通用性。\r\n关键词:CPLD;VHDL;交通灯控制器\r\n中图分类号:TP39\r\nAbstract :This paper introduces the electronic-traffic lamp, which is based on the VHDL and is com

    标签: CPLD 芯片 十字路口 交通灯

    上传时间: 2013-08-11

    上传用户:aesuser

  • 用fpga实现的DA转换器

    用fpga实现的DA转换器,有说明和源码,VDHL文件。\\r\\nA PLD Based Delta-Sigma DAC\\r\\nDelta-Sigma modulation is the simple, yet powerful,\\r\\ntechnique responsible for the extraordinary\\r\\nperformance and low cost of today s audio CD\\r\\nplayers. The simplest Delta-Sigm

    标签: fpga DA转换器

    上传时间: 2013-08-22

    上传用户:dudu1210004

  • US Navy VHDL Modelling Guide

      This document was developed under the Standard Hardware and Reliability Program (SHARP) TechnologyIndependent Representation of Electronic Products (TIREP) project. It is intended for use by VHSIC HardwareDescription Language (VHDL) design engineers and is offered as guidance for the development of VHDL modelswhich are compliant with the VHDL Data Item Description (DID DI-EGDS-80811) and which can be providedto manufacturing engineering personnel for the development of production data and the subsequent productionof hardware. Most VHDL modeling performed to date has been concentrated at either the component level orat the conceptual system level. The assembly and sub-assembly levels have been largely disregarded. Under theSHARP TIREP project, an attempt has been made to help close this gap. The TIREP models are based upon lowcomplexity Standard Electronic Modules (SEM) of the format A configuration. Although these modules are quitesimple, it is felt that the lessons learned offer guidance which can readily be applied to a wide range of assemblytypes and complexities.

    标签: Modelling Guide Navy VHDL

    上传时间: 2014-12-23

    上传用户:xinhaoshan2016

  • 2012TI电子设计大赛——微弱信号检测装置

    微弱信号检测装置 四川理工学院 刘鹏飞、梁天德、曾学明 摘要: 本设计以TI的Launch Pad为核心板,采用锁相放大技术设计并制作了一套微弱信号检测装置,用以检测在强噪声背景下已知频率微弱正弦波信号的幅度值,并在液晶屏上数字显示出所测信号相应的幅度值。实验结果显示其抗干扰能力强,测量精度高。 关键词:强噪声;微弱信号;锁相放大;Launch Pad Abstract: This design is based on the Launch Pad of TI core board, using a lock-in amplifier technique designed and produced a weak signal detection device, to measure the known frequency sine wave signal amplitude values of the weak in the high noise background, and shows the measured signal amplitude of the corresponding value in the liquid crystal screen. Test results showed that it has high accuracy and strong anti-jamming capability. Keywords: weak signal detection; lock-in-amplifier; Launch Pad  1、引言 随着现代科学技术的发展,在科研与生产过程中人们越来越需要从复杂高强度的噪声中检测出有用的微弱信号,因此对微弱信号的检测成为当前科研的热点。微弱信号并不意味着信号幅度小,而是指被噪声淹没的信号,“微弱”也仅是相对于噪声而言的。只有在有效抑制噪声的条件下有选择的放大微弱信号的幅度,才能提取出有用信号。微弱信号检测技术的应用相当广泛,在生物医学、光学、电学、材料科学等相关领域显得愈发重要。 2、方案论证 针对微弱信号的检测的方法有很多,比如滤波法、取样积分器、锁相放大器等。下面就针对这几种方法做一简要说明。 方案一:滤波法。 在大部分的检测仪器中都要用到滤波方法对模拟信号进行一定的处理,例如隔离直流分量,改善信号波形,防止离散化时的波形混叠,克服噪声的不利影响,提高信噪比等。常用的噪声滤波器有:带通、带阻、高通、低通等。但是滤波方法检测信号不能用于信号频谱与噪声频谱重叠的情况,有其局限性。虽然可以对滤波器的通频带进行调节,但其噪声抑制能力有限,同时其准确性与稳定性将大打折扣。

    标签: 2012 TI 电子设计大赛 微弱信号

    上传时间: 2013-11-04

    上传用户:lty6899826

  • ISM射频产品的晶体频率计算

    Abstract: Many industrial/scientific/medical (ISM) band radio frequency (RF) products use crystal oscillators to generate areference for the phase-locked loop (PLL)-based local oscillator (LO). This tutorial provides a basic description of theISM-RF Crystal Calculator, which can be used to calculate various impacts on crystal frequency accuracy and startupmargin for such an LO.  

    标签: ISM 射频 晶体频率 计算

    上传时间: 2013-11-15

    上传用户:JasonC

  • COOLMOS全面认识

    Recently a new technology for high voltage Power MOSFETshas been introduced – the CoolMOS™ . Based on thenew device concept of charge compensation the RDS(on) areaproduct for e.g. 600V transistors has been reduced by afactor of 5. The devices show no bipolar current contributionlike the well known tail current observed during the turn-offphase of IGBTs. CoolMOS™ virtually combines the lowswitching losses of a MOSFET with the on-state losses of anIGBT.

    标签: COOLMOS

    上传时间: 2013-11-14

    上传用户:zhyiroy