绘制复杂图片代码,包括散点图、柱状图、趋势图、饼图等,或者几种图形的合图
上传时间: 2015-08-30
上传用户:hzy5825468
凸包最常用的凸包算法是Graham扫描法和Jarvis步进法.本程序用Graham扫描法实现凸包的绘制
上传时间: 2015-09-02
上传用户:yt1993410
将VB良好的界面显示功能与Matlab强大的数据处理和图形绘制功能相结合,设计了机械控制工程实验系统的人机界面.
上传时间: 2014-01-26
上传用户:海陆空653
通过三维有限元计算来研究含圆孔有限厚度板的圆孔边缘应力场,找出了应力集中系数与板的厚度、 圆孔半径之间的关系,同时还分析了圆孔边缘的三维应力约束程度和三维应力约束区域的大小. 研究结果表 明:离面应力约束系数在板的中面最大,而在表面为0 ,三维应力约束影响区域的长度约为板厚的一半 应力 集中系数沿厚度的分布是不均匀的,其最大值及位置与厚度有关 有限厚度板中面的应力集中系数及其最大 值均大于平面应力或平面应变的应力集中系数 对含圆孔任意厚度板的应力集中问题,按平面应力或平面应 变来考虑是不安全的 Sternberg 等人对含圆孔任意厚度板的应力分布及应力集中系数的近似三维求解,仅适 用于厚度较小的板,当板超过一定厚度时同样也是不安全的. 关键词: 应力集中系数 有限元分析 有限厚度板
上传时间: 2014-12-02
上传用户:wendy15
用c++编写的画圆程序,能直接运行!真是太棒 了
上传时间: 2014-12-04
上传用户:cjf0304
ADS开发环境下的绘制图形GUI软件包,控制液晶屏或者OLED均可
上传时间: 2013-12-29
上传用户:Shaikh
圆 圆 圆 圆 圆 圆 圆 圆 圆 圆 圆
标签:
上传时间: 2013-12-25
上传用户:siguazgb
基于jfreechart组件的矢量图绘制
标签: jfreechart 矢量图 绘制
上传时间: 2015-09-16
上传用户:坏天使kk
程序实现Java环境下3D模型的绘制,运行程序前,请先配置好Java 3d的运行环境,java 3d 开发包请到sun官方网站下载
上传时间: 2013-12-13
上传用户:zwei41
在MATLAB并无直接指令可进行画圆,本程序是一个不错的画圆程序。
上传时间: 2014-12-01
上传用户:15071087253