基于TMS320F2812 光伏并网发电模拟装置PROTEL设计原理图+PCB+软件源码+WORD论文文档,硬件采用2层板设计，PROTEL99SE 设计的工程文件，包括完整的原理图和PCB文件，可以做为你的学习设计参考。 摘要：本文实现了一个基于TMS320F2812 DSP芯片的光伏并网发电模拟装置，采用直流稳压源和滑动变阻器来模拟光伏电池。通过TMS320F2812 DSP芯片ADC模块实时采样模拟电网电压的正弦参考信号、光伏电池输出电压、负载电压电流反馈信号等。经过数据处理后，用PWM模块产生实时的SPWM 波，控制MOSFET逆变全桥输出正弦波。本文用PI控制算法实现了输出信号对给定模拟电网电压的正弦参考信号的频率和相位跟踪，用恒定电压法实现了光伏电池最大功率点跟踪（MPPT），从而达到模拟并网的效果。另外本装置还实现了光伏电池输出欠压、负载过流保护功能以及光伏电池输出欠压、过流保护自恢复功能、声光报警功能、孤岛效应的检测、保护与自恢复功能。系统测试结果表明本设计完全满定设计要求。关键词：光伏并网，MPPT，DSP Photovoltaic Grid-connected generation simulator Zhangyuxin，Tantiancheng，Xiewuyang(College of Electrical Engineering, Chongqing University)Abstract: This paper presents a photovoltaic grid-connected generation simulator which is based on TMS320F2812 DSP, with a DC voltage source and a variable resistor to simulate the characteristic of photovoltaic cells. We use the internal AD converter to real-time sampling the referenced grid voltage signal, outputting voltage of photovoltaic, feedback outputting voltage and current signal. The PWM module generates SVPWM according to the calculation of the real-time sampling data, to control the full MOSFET inverter bridge output sine wave. We realized that the output voltage of the simulator can track the frequency and phase of the referenced grid voltage with PI regulation, and the maximum photovoltaic power tracking with constant voltage regulation, thereby achieved the purpose of grid-connected simulation. Additionally, this device has the over-voltage and over-current protection, audible and visual alarm, islanding detecting and protection, and it can recover automatically. The testing shows that our design is feasible.Keywords: Photovoltaic Grid-connected，MPPT，DSP 目录引言 11. 方案论证 11.1. 总体介绍 11.2. 光伏电池模拟装置 11.3. DC-AC逆变桥 11.4. MOSFET驱动电路方案 21.5. 逆变电路的变频控制方案 22. 理论分析与计算 22.1. SPWM产生 22.1.1. 规则采样法 22.1.2. SPWM 脉冲的计算公式 32.1.3. SPWM 脉冲计算公式中的参数计算 32.1.4. TMS320F2812 DSP控制器的事件管理单元 42.1.5. 软件设计方法 62.2. MPPT的控制方法与参数计算 72.3. 同频、同相的控制方法和参数计算 8
标签： tms320f2812 光伏 并网发电 模拟 protel pcb
上传时间： 2021-11-02
上传用户：ooaaooxx
FFeeaattuurreess Input voltage range: 2.2 to 6V Programmable LED Current Drives LEDs Up to 27V Switching Frequency：up to 800KHz Wide dimming frequency range: 20KHz~ 360 KHz Programmable Overvoltage Protection Tiny SOP8/PP Package
标签： HX3248C
上传时间： 2021-11-05
上传用户：aben
Wide 2.2V to 6V Input Voltage Range 0.20V FB adjustable LED drive current Directly drive 9 Series 1W LED at VIN>=6V Fixed 800KHz Switching Frequency Max. 3A Switching Current Capability Up to 92% efficiency Excellent line and load regulation EN PIN TTL shutdown capability Internal Optimize Power MOSFET
标签： sc3633
上传时间： 2021-11-05
上传用户：d1997wayne
2.7V to 5.5V input voltage Range Efficiency up to 96% 24V Boost converter with 12A switch current Limit 600KHz fixed Switching Frequency Integrated soft-start Thermal Shutdown Under voltage Lockout Support external LDO auxiliary power supply 8-Pin SOP-PP PackageAPPLICATIONSPortable Audio Amplifier Power SupplyPower BankQC 2.0/Type CWireless ChargerPOS Printer Power SupplySmall Motor Power Supply
标签： XR2981
上传时间： 2021-11-05
上传用户：13692533910
1. Scope ......................................................................................................................................................................... 12. DDR4 SDRAM Package Pinout and Addressing ....................................................................................................... 22.1 DDR4 SDRAM Row for X4,X8 and X16 ................................................................................................................22.2 DDR4 SDRAM Ball Pitch........................................................................................................................................22.3 DDR4 SDRAM Columns for X4,X8 and X16 ..........................................................................................................22.4 DDR4 SDRAM X4/8 Ballout using MO-207......................................................................................................... 22.5 DDR4 SDRAM X16 Ballout using MO-207.............................................................................................................32.6 Pinout Description ..................................................................................................................................................52.7 DDR4 SDRAM Addressing.....................................................................................................................................73. Functional Description ...............................................................................................................................................83.1 Simplified State Diagram ....................................................................................................................................83.2 Basic Functionality..................................................................................................................................................93.3 RESET and Initialization Procedure .....................................................................................................................103.3.1 Power-up Initialization Sequence .............................................................................................................103.3.2 Reset Initialization with Stable Power ......................................................................................................113.4 Register Definition ................................................................................................................................................123.4.1 Programming the mode registers .............................................................................................................123.5 Mode Register ......................................................................................................................................................134. DDR4 SDRAM Command Description and Operation ............................................................................................. 244.1 Command Truth Table ..........................................................................................................................................244.2 CKE Truth Table ...................................................................................................................................................254.3 Burst Length, Type and Order ..............................................................................................................................264.3.1 BL8 Burst order with CRC Enabled .........................................................................................................264.4 DLL-off Mode & DLL on/off Switching procedure ................................................................................................274.4.1 DLL on/off switching procedure ...............................................................................................................274.4.2 DLL “on” to DLL “off” Procedure ..............................................................................................................274.4.3 DLL “off” to DLL “on” Procedure ..............................................................................................................284.5 DLL-off Mode........................................................................................................................................................294.6 Input Clock Frequency Change ............................................................................................................................304.7 Write Leveling.......................................................................................................................................................314.7.1 DRAM setting for write leveling & DRAM termination function in that mode ............................................324.7.2 Procedure Description .............................................................................................................................334.7.3 Write Leveling Mode Exit .........................................................................................................................34
标签： DDR4
上传时间： 2022-01-09
上传用户：13692533910
The PW5410B is a low noise, constant frequency (1.2MHz) switched capacitor voltage doubler. Itproduces a regulated output voltage from 1.8V to 5V input with up to 100mA of output current. Lowexternal parts count (one flying capacitor and two small bypass capacitors at VIN and VOUT) makethe PW5410B ideally suited for small, battery-powered applications
标签： pw5410
上传时间： 2022-02-11
上传用户：wangshoupeng199
The PW5410A is a low noise, constant frequency (1.2MHz) switched capacitor voltage doubler. Itproduces a regulated output voltage from 2.7V to 5V input with up to 250mA of output current. Lowexternal parts count (one flying capacitor and two small bypass capacitors at VIN and VOUT) makethe PW5410A ideally suited for small, battery-powered applications
标签： pw5410
上传时间： 2022-02-11
上传用户：nicholas28
The PW5200A/ PW5200C is high efficiency synchronous, PWM step-up DC/DC converters optimizedto provide a high efficient solution to medium power systems. The devices work with a 1.4MHz fixedfrequency switching. These features minimize overall solution footprint by allowing the use of tiny,low profile inductors and ceramic capacitors. Automatic PWM/PFM mode switching at light loadsaves power and improves efficiency
标签： pw5200
上传时间： 2022-02-11
上传用户：joshau007
PW2330 develops a high efficiency synchronous step down DC-DC converter capable of delivering3A output current. PW2330 operates over a wide input voltage range from 4.5V to 30V andintegrates main switch and synchronous switch with very low RDS(ON) to minimize the conductionloss. PW2330 adopts the proprietary instant PWM architecture to achieve fast transient responsesfor high step down applications and high efficiency at light loads. In addition, it operates atpseudo-constant frequency of 500kHz under continuous conduction mode to minimize the size ofinductor and capacitor
标签： pw2330
上传时间： 2022-02-11
上传用户：GGMD
The PW2312 is a high frequency, synchronous, rectified, step-down, switch-mode converter withinternal power MOSFETs. It offers a very compact solution to achieve a 1.5A peak output currentover a wide input supply range, with excellent load and line regulation.The PW2312 requires a minimal number of readily available, external components and is available ina space saving SOT23-6 package.
标签： pw2312
上传时间： 2022-02-11
上传用户：qingfengchizhu
