Lots useful AVR asm math routines (trigonometry, float point, intenger , vectors and etc)
标签： trigonometry intenger routines vectors
上传时间： 2017-09-08
上传用户：AbuGe
JMS是用于和面向消息的中间件相互通信的应用程序接口。它既支持点对点(point-to-point)的域，又支持发布/订阅(publish/subscribe)类型的域，并且提供对下列类型的支持：经认可的消息传递,事务型消息的传递，一致性消息和具有持久性的订阅者支持。JMS还提供了另一种方式来对您的应用与旧的后台系统相集成。
标签： point-to-point JMS 互通 应用程序
上传时间： 2014-01-09
上传用户：1427796291
This book is about multipoint cooperative communication, a key technology to overcome the long-standing problem of limited transmission rate caused by inter- point interference. However, the multipoint cooperative communication is not an isolated technology. Instead, it covers a vast range of research areas such as the multiple-input multiple-outputsystem, the relay network, channel state information issues, inter-point radio resource management operations, coordinated or joint transmissions, etc. We suppose that any attempt trying to thoroughly analyze the multipoint cooperative communication technology might end up working on a cyclopedia for modern communication systems and easily get lost in discussing all kinds of cooperative communication schemes as well as the associated models and their variations.
标签： Communication Multi-point Cooperative Systems
上传时间： 2020-05-31
上传用户：shancjb
逆变器作为光伏阵列和电网接口的主要设备，它的性能决定着整个光伏发电系统的性能。为了将光伏阵列产生的电能最大限度地馈入电网，并提高其运行的稳定度、可靠性和精确度，必须对并网逆变器的主电路拓扑选择、滤波器参数设计及其控制策略选取等进行深入研究。 论文首先分析了光伏发电的国内外发展现状和应用前景，对光伏并网发电系统的种类、结构和并网标准进行了综述。针对众多适用于光伏并网的逆变器拓扑进行了详细的比较分析，最终确定了一台单相满载功率1kW、并网电压220V的逆变器拓扑及其主电路参数，对其输出滤波器参数进行设计，并对其进行了幅频特性分析。 其次，详细分析和研究逆变器的并网控制策略，确定了在独立工作模式下的瞬时电压控制策略和在并网工作模式下的瞬时电流控制策略。根据选定的控制策略分别对其控制系统进行了建模和闭环参数设计，并利用Sabet软件进行系统仿真，验证了系统建模和设计的正确性。 接着，在分析光伏阵列特性的基础上，总结和比较了常用的几种MPPT（Maximum Power Point Tracking）控制方法，通过扰动观测法对并网逆变器输出电流的控制，实现了光伏阵列的MPPT，并给出了设计方案和实验验证。 最后，根据以上分析结果，研制了一台基于DSP控制的光伏并网逆变器的试验样机，并详述了其软硬件的设计方案，给出了相关实验结果。
上传时间： 2013-04-24
上传用户：天天天天
·详细说明：DTMF检测程序。定点计算，可移植到DSP上。 Usage: dtmf filename -DTMF examination procedure. The fixed point calculation, may transplant to DSP on. Usage: Dtmf filename 文件列表: alaw.cpp alaw.h &nb
上传时间： 2013-06-25
上传用户：sowhat
Many CAD users dismiss schematic capture as a necessary evil in the process of creating\r\nPCB layout but we have always disputed this point of view. With PCB layout now offering\r\nautomation of both component placement and track routing, getting the des
标签： schematic necessary creating dismiss
上传时间： 2013-09-25
上传用户：baiom
Abstract: IC switches and multiplexers are proliferating, thanks to near-continual progress in lowering the supply voltage,incorporating fault-protected inputs, clamping the output voltage, and reducing the switch resistances. The latest of these advancesis the inclusion of precision resistors to allow two-point calibration of gain and offset in precision data-acquisition systems.
上传时间： 2013-11-12
上传用户：acwme
This paper presents a space vector modulation(SVM)-based switching strategy for a three-level neutral point clamped (NPC) converter that is adapted as a STATCOM.
上传时间： 2013-10-20
上传用户：zyt
The MAX2691 low-noise amplifier (LNA) is designed forGPS L2 applications. Designed in Maxim’s advancedSiGe process, the device achieves high gain andlow noise figure while maximizing the input-referred 1dBcompression point and the 3rd-order intercept point. TheMAX2691 provides a high gain of 17.5dB and sub 1dBnoise figure.
标签： Amplifier Low-Noise 2691 Band
上传时间： 2014-12-04
上传用户：zaocan888
Sensors for pressure, load, temperature, acceleration andmany other physical quantities often take the form of aWheatstone bridge. These sensors can be extremely linearand stable over time and temperature. However, mostthings in nature are only linear if you don’t bend them toomuch. In the case of a load cell, Hooke’s law states that thestrain in a material is proportional to the applied stress—as long as the stress is nowhere near the material’s yieldpoint (the “point of no return” where the material ispermanently deformed).
上传时间： 2013-11-13
上传用户：墙角有棵树
