虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

FIFOs

  • This paper will discuss the design of an asynchronous FIFO,Asynchronous FIFOs are widely used in the

    This paper will discuss the design of an asynchronous FIFO,Asynchronous FIFOs are widely used in the computer networking industry to receive data at a particular frequency and transmit them at another frequency. An asynchronous FIFO has two different clocks: one for read and one for write.

    标签: Asynchronous asynchronous the discuss

    上传时间: 2013-12-09

    上传用户:Thuan

  • XAPP807-封装最小的三态以太网MAC处理引擎

    The Tri-Mode Ethernet MAC (TEMAC) UltraController-II module is a minimal footprint,embedded network processing engine based on the PowerPC™ 405 (PPC405) processor coreand the TEMAC core embedded within a Virtex™-4 FX Platform FPGA. The TEMACUltraController-II module connects to an external PHY through Gigabit Media IndependentInterface (GMII) and Management Data Input/Output (MDIO) interfaces and supports tri-mode(10/100/1000 Mb/s) Ethernet. Software running from the processor cache reads and writesthrough an On-Chip Memory (OCM) interface to two FIFOs that act as buffers between thedifferent clock domains of the PPC405 OCM and the TEMAC.

    标签: XAPP 807 MAC 封装

    上传时间: 2013-10-26

    上传用户:yuzsu

  • The first task at hand is to set up the endpoints appropriately for this example. The following code

    The first task at hand is to set up the endpoints appropriately for this example. The following code switches the CPU clock speed to 48 MHz (since at power-on default it is 12 MHz), and sets up EP2 as a Bulk OUT endpoint, 4x buffered of size 512, and EP6 as a Bulk IN endpoint, also 4x buffered of size 512. This set-up utilizes the maximum allotted 4-KB FIFO space. It also sets up the FIFOs for manual mode, word-wide operation, and goes through a FIFO reset and arming sequence to ensure that they are ready for data operations

    标签: appropriately The endpoints following

    上传时间: 2013-12-02

    上传用户:dianxin61

  • Enhanced version of the Serial Peripheral Interface available on Motorola s MC68HC11 family of CPUs.

    Enhanced version of the Serial Peripheral Interface available on Motorola s MC68HC11 family of CPUs.Enhancements include a wider supported operating frequency range, 4deep read and write FIFOs, and programmable transfer count dependent interrupt generation. As with the SPI found in MC68HC11 processors the core features programmable clock phase [CPHA] and clock polarity [CPOL]. The core features an 8bit wishbone interface. Very simple, very small.

    标签: Peripheral Interface available Enhanced

    上传时间: 2014-12-06

    上传用户:invtnewer

  • 这个设计是使用Virtex-4实现DDR的控制器的

    这个设计是使用Virtex-4实现DDR的控制器的,设计分为三个主要模块:Front-End FIFOs,DDR SDRAM Controller和Datapath Module。其中主要是DDR SDRAM Controller,当然还有测试模块。

    标签: Virtex DDR 控制器

    上传时间: 2017-05-20

    上传用户:llandlu

  • A badic controller for the UART. It incorporates a -- transmit and receive FIFO (fr

    A badic controller for the UART. It incorporates a -- transmit and receive FIFO (from Max+Plus II s MegaWizard -- plug-in manager). Note that no checking is done to see -- whether the FIFOs are overflowing or not. This strictly -- handles the transmitting and receiving of the data.

    标签: incorporates controller transmit receive

    上传时间: 2017-09-05

    上传用户:13681659100