虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

Electric

  • Procyon方案(手工制作的MP3播放器电路及资料)

    ·详细说明:Procyon方案(手工制作的MP3播放器电路及资料)-procyon plan, hand-planted MP3 player Electric circuit and material 文件列表:   procyon方案   ...........\Code   ...........\....\ata_if.c   ...........\

    标签: Procyon MP3 方案 播放器

    上传时间: 2013-05-21

    上传用户:qweqweqwe

  • 外挂硬盘和FLASH的MP3播放器解决方案

    ·详细说明:外挂硬盘和FLASH的MP3播放器解决方案,用C和汇编编写,并附带有电路原理图- Outside hangs the hard disk and the FLASH MP3 player solution, with C and the assembly compilation, and has the Electric circuit schematic diagram in pass

    标签: FLASH MP3 硬盘 播放器

    上传时间: 2013-06-12

    上传用户:yangbo69

  • 晶体振荡器设计,以满足您的应用

    Abstract: Quartz crystals are mechanical resonators with piezoElectric properties. The piezoElectricproperties (Electric potential across the crystal is proportional to mechanical deformation) allow their use

    标签: 晶体振荡器

    上传时间: 2013-10-17

    上传用户:时代将军

  • 电路分析基础pdf

    电路分析基础电路分析基础Fundamentals of Electric CircuitsFundamentals of Electric Circuits多媒体教学课件多媒体教学课件北京理工大学北京理工大学Beijing Institute of TechnologyBeijing Institute of Technology 目录•第一章集总电路中电压、电流的约束关系•第二章运用独立电流、电压变量的分析方法•第四章分解法及单口网络•第三章叠加方法与网络函数•第六章电容元件和电感元件•第七章一阶电路•第八章二阶电路•第十章正弦稳态功率和能量三相电路•第九章阻抗与导纳•第十一章电路的频率响应•第十二章耦合电感和理想变压器

    标签: 电路分析基础

    上传时间: 2013-11-10

    上传用户:asdstation

  • 计算FR4上的差分阻抗(PDF)

    Calculation of the Differential Impedance of Tracks on FR4 substrates There is a discrepancy between calculated and measured values of impedance for differential transmission lineson FR4. This is especially noticeable in the case of surface microstrip configurations. The anomaly is shown tobe due to the nature of the substrate material. This needs to be considered as a layered structure of epoxy resinand glass fibre. Calculations, using Boundary Element field methods, show that the distribution of the Electricfield within this layered structure determines the apparent diElectric constant and therefore affects theimpedance. Thus FR4 cannot be considered to be uniform diElectric when calculating differential impedance.

    标签: FR4 计算 差分阻抗

    上传时间: 2014-12-24

    上传用户:DE2542

  • 智能电表和智能电网手册

    Abstract: Investment in smart meters and smart grid end equipment continues to grow worldwide as countriestry to make their Electric delivery systems more efficient. However, as critical as the Electric deliveryinfrastructure is, it is normally not secured and thus subject to attack. This article describes the concept oflife-cycle security—the idea that embedded equipment in the smart grid must have security designed into theentire life of the product, even back to the contract manufacturer. We also talk about how life-cycle securityapplies to embedded equipment in the smart grid. Potential threats are discussed, as are potential solutionsto mitigate the risks posed by those threats.

    标签: 智能电表 智能电网

    上传时间: 2014-12-24

    上传用户:熊少锋

  • G3-PLC技术使电动汽车智能化充电

    Abstract: This article explores criteria necessary for reliable communication between Electric vehicles (EVs) and Electric vehicleservice equipment (EVSE). Data will demonstrate that a G3-PLC system has already met the criteria established by the automotiveand utility industries. Multiple international tests prove that a G3-PLC implementation is the optimal low-frequency solution.

    标签: PLC 电动汽车 智能化 充电

    上传时间: 2014-12-24

    上传用户:逗逗666

  • 基于开关电容技术的锁定放大器设计

    锁定放大是微弱信号检测的重要手段。基于相关检测理论,利用开关电容的开关实现锁定放大器中乘法器的功能,提出开关电容和积分器相结合以实现相关检测的方法,并设计出一种锁定放大器。该锁定放大器将微弱信号转化为与之相关的方波,通过后续电路得到正比于被测信号的直流电平,为后续采集处理提供方便。测量数据表明锁定放大器前级可将10-6 A的电流转换为10-1 V的电压,后级通过带通滤波器级联可将信号放大1×105倍。该方法在降低噪声的同时,可对微弱信号进行放大,线性度较高、稳定性较好。 Abstract:  Lock-in Amplifying(LIA)is one of important means for weak signal detection. Based on cross-correlation detection theory, switch in the swithched capacitor was used as multiplier of LIA, and a new method of correlation detection was proposed combining swithched capacitor with integrator. A kind of LIA was designed which can convert the weak signal to square-wave, then DC proportional to measured signal was obtained through follow-up conditioning circuit, providing convenience for signal acquisition and processing. The measured data shows that the Electric current(10-6 A) can be changed into voltage(10-1 V) by LIA, and the signal is magnified 1×105 times by cascade band-pass filter. The noise is suppressed and the weak signal is amplified. It has the advantages of good linearity and stability.

    标签: 开关电容 锁定放大器

    上传时间: 2013-11-29

    上传用户:黑漆漆

  • 基于AVR单片机的闭环控制系统

      针对科研实验中对拉压千斤顶加载过程控制的需要,采用ATmega128单片机控制步进电机进而实现对执行系统的电动泵站实行自动控制。对力和位移的数据采集与处理及用步进电机控制电动泵站手柄的技术细节作了重点描述。通过单片机的A/D变换器对AMP放大模块采集的电桥信号作量化处理,千斤顶的操控手柄位置依电动油泵阀门开启的方向和大小作若干定位,单片机根据力或位移传感器信号,实时控制步进电机驱动手柄旋转到相应操控位置。   Abstract:   This article describes the use of ATmega128 AVR microcontroller series of DBS Electric pumping stations and QF100/200 separate twoway hydraulic jack to automate the process of manipulating the work of the technical content. Articles on force and displacement data acquisition and processing, and stepper motor control Electric pump with the handle of the key technical details were described. Through the MCU’s A / D converter module is collected on the AMP amplification quantify the signal bridge, jack handle position control valve opening according to the direction of Electric pumps for a number of positioning and size of the microcontroller based on force or displacement sensor signals, real-time control stepper motor drive control handle rotate to the appropriate location.  

    标签: AVR 单片机 闭环控制

    上传时间: 2014-01-16

    上传用户:hasan2015

  • 基于凌阳单片机的步进电机加减速的控制方法

    提出一种基于凌阳单片机的步进电机加减速的控制方法。采用凌阳科技推出的16位结构工控单片机SPMC75F2413A为控制器,由Allegro公司生产的两相步进电机专用驱动器件SLA7042M构成步进电机的驱动电路,在传统的3段直线加减速控制算法基础上增加至7段S形曲线加减速过程,控制步进电机的启动和停止。实验结果表明,该控制方法克服了直线加减速中不连续、易造成系统冲击的问题,整个系统实现柔性控制,电机启动、停止连续性能提高30%。 Abstract:  The method of controlled stepping motor is referred based on SPMC75F2413A MCU, which adopts the 16 knots SPMC75F2413A MCU as the controller. The special-purpose actuation chip SLA7042M of two stepping motor produced by Allegro Corporation constituted to actuation Electric circuit. The purpose of increasing to seven section of S shape curve based on the traditional three sections of straight line is to control the start and stop process of stepping motor. The experimental results show that the control method solves easy to pull-out and overshot problems. The overall system realizes flexible control, and the performance of motor start or stop continuity is increased 30%

    标签: 凌阳单片机 步进电机 控制方法

    上传时间: 2013-12-08

    上传用户:jiangfire