usb 端点测试程序 块传输 从EP6输入512字到EP2传出。
上传时间： 2013-12-30
上传用户：ryb
使用Usb cy7c68013与DSP通信，现在已经能够很正确的传递（上传数据）了。 USB资源： 使用了Ep２，Ep６ Ep2, out auto EP6, in auto FlagA－－－ PF3 FlagB－－－ PF6 FlagC－－－ PF1 需要 EP２ EMPTY EP6 FULL信号 因此 FlagA－－－ PF3 －－－ EP2空 －－－ ８ h FlagB－－－ PF6 －－－ EP6满 －－－ e h FlagC－－－ PF1 PINFLAGSAB＝0xE8 极性设置： PKTEND，EPEF，EPFF high 其他的低 因此 FIFOPINPOLAR = 0x23 包结束信号接在DSP 的 PF７ 上面。 以上结束06.11.28
上传时间： 2015-12-27
上传用户：youke111
bulk endpoint endless source/sink firmware. EP2OUT will always accept a bulk OUT EP4OUT will always accept a bulk OUT EP6IN will always return a 512 byte packet. The packet contains an incrementing byte starting at 0x02. Since EP6 always returns a 512 byte packet, this endpoint should never be accessed except with a high-speed host controller. EP8IN will continuously return the packet most recently written to EP4OUT
标签： bulk will endpoint firmware
上传时间： 2016-01-14
上传用户：sk5201314
The first task at hand is to set up the endpoints appropriately for this example. The following code switches the CPU clock speed to 48 MHz (since at power-on default it is 12 MHz), and sets up EP2 as a Bulk OUT endpoint, 4x buffered of size 512, and EP6 as a Bulk IN endpoint, also 4x buffered of size 512. This set-up utilizes the maximum allotted 4-KB FIFO space. It also sets up the FIFOs for manual mode, word-wide operation, and goes through a FIFO reset and arming sequence to ensure that they are ready for data operations
标签： appropriately The endpoints following
上传时间： 2013-12-02
上传用户：dianxin61
使用68013的测试程序，包含68013固件程序（采用slave FIFO bulk同步读写，EP2 OUT，EP6 IN），驱动，PC端测试用程序。CPLD的VHDL代码
上传时间： 2013-11-29
上传用户：luke5347
