这是关于Simulation and DSP Board Implementation of an Optical Transmission的资料，拿出来与大家分享。
标签： Implementation Transmission Simulation Optical
上传时间： 2014-12-20
上传用户：youmo81
this a book about protel99se,whick is used for designing electric board,
标签： designing electric protel about
上传时间： 2015-11-12
上传用户：cx111111
CMX990 demonstration board (DE9901)
标签： demonstration board 9901 CMX
上传时间： 2015-11-12
上传用户：GHF
hyesco AT91RM9200 board boot source code
上传时间： 2014-01-12
上传用户：ouyangtongze
SDRAM Controller For Altera SOPC Builder and NIOS on DE2 kit board
标签： Controller Builder Altera SDRAM
上传时间： 2015-11-25
上传用户：tuilp1a
SRAM Controller For Altera SOPC Builder and NIOS on DE2 kit board
标签： Controller Builder Altera board
上传时间： 2015-11-25
上传用户：yzy6007
RS232 Controller For Altera SOPC Builder and NIOS on DE2 kit board
标签： Controller Builder Altera board
上传时间： 2013-12-27
上传用户：busterman
DE2_PIO Controller For Altera SOPC Builder and NIOS on DE2 kit board
标签： Controller Builder Altera board
上传时间： 2015-11-25
上传用户：mikesering
This leon3 design is tailored to the Altera NiosII Startix2 Development board, with 16-bit DDR SDRAM and 2 Mbyte of SSRAM. As of this time, the DDR interface only works up to 120 MHz. At 130, DDR data can be read but not written. NOTE: the test bench cannot be simulated with DDR enabled because the Altera pads do not have the correct delay models. * How to program the flash prom with a FPGA programming file 1. Create a hex file of the programming file with Quartus. 2. Convert it to srecord and adjust the load address: objcopy --adjust-vma=0x800000 output_file.hexout -O srec fpga.srec 3. Program the flash memory using grmon: flash erase 0x800000 0xb00000 flash load fpga.srec
标签： Development Startix2 tailored Altera
上传时间： 2014-01-19
上传用户：chongcongying
This is a document of embedded system board PXA270L. the core is based on Xscale.
标签： document embedded Xscale system
上传时间： 2015-11-27
上传用户：wfeel
