JXTA™ is a set of open, generalized peer-to-peer (P2P) protocols that allow any networked device — sensors, cell phones, PDAs, laptops, workstations, servers and supercomputers — to communicate and collaborate mutually as peers
标签： peer-to-peer generalized networked protocols
上传时间： 2017-06-03
上传用户：gtf1207
JXTA™ is a set of open, generalized peer-to-peer (P2P) protocols that allow any networked device — sensors, cell phones, PDAs, laptops, workstations, servers and supercomputers — to communicate and collaborate mutually as peers
标签： peer-to-peer generalized networked protocols
上传时间： 2017-06-03
上传用户：xzt
移动电话主要采用频率复用，但分配给移动电话的频段很少，远不能满足用户的需要。 因此就提出将地区划分成小区，称为蜂窝（Cell），每个蜂窝内使用一组频率，相隔一段距离后，相同的频率又可重复使用。
上传时间： 2013-12-27
上传用户：Ants
GNU_Radio GNU radio is a free/open-source software toolkit for and the content is controlled by a handful of organizations. Cell building software radios, in which software defines the phones are a great convenience, but the features your phone transmitted waveforms and demodulates the received supports are determined by the operator s interests, not yours. waveforms. Software radio is the technique of getting code A centralized system limits the rate of innovation. Instead of as close to the antenna as possible. It turns radio hardware cell phones being second-class citizens, usable only if problems into software problems.
标签： open-source GNU_Radio software toolkit
上传时间： 2017-06-27
上传用户：拔丝土豆
Some time ago, I stated in another article that I d take the idea of location broadcasting and develop a mobile solution as a follow-up. The problem back then was I had no means to get location data off of a cell phone, or a way to make it useful. My, how times have changed since then! In this article, I ll demonstrate how to get your phone s GPS coordinates…
标签： broadcasting location another article
上传时间： 2013-12-25
上传用户：李梦晗
一种双频微带天线方案的分析与设计
标签： antenna
上传时间： 2015-05-05
上传用户：puzzle0612
High-speed Precision Numerically Controlled Tapping Using Dual Predictive Control
标签： 神经网络控制
上传时间： 2016-07-20
上传用户：ss183968ss
The AP2406 is a 1.5Mhz constant frequency, slope compensated current mode PWM step-down converter. The device integrates a main switch and a synchronous rectifier for high efficiency without an external Schottky diode. It is ideal for powering portable equipment that runs from a single cell lithium-Ion (Li+) battery. The AP2406 can supply 600mA of load current from a 2.5V to 5.5V input voltage. The output voltage can be regulated as low as 0.6V. The AP2406 can also run at 100% duty cycle for low dropout operation, extending battery life in portable system. Idle mode operation at light loads provides very low output ripple voltage for noise sensitive applications. The AP2406 is offered in a low profile (1mm) 5-pin, thin SOT package, and is available in an adjustable version and fixed output voltage of 1.2V, 1.5V and 1.8V
上传时间： 2017-02-23
上传用户：w124141
High-Speed, Low-Power Dual Operational Amplifier The AD826 features high output current drive capability of 50 mA min per amp, and is able to drive unlimited capacitive loads. With a low power supply current of 15 mA max for both amplifiers, the AD826 is a true general purpose operational amplifier. The AD826 is ideal for power sensitive applications such as video cameras and portable instrumentation. The AD826 can operate from a single +5 V supply, while still achieving 25 MHz of band width. Furthermore the AD826 is fully specified from a single +5 V to ±15 V power supplies. The AD826 excels as an ADC/DAC buffer or active filter in data acquisition systems and achieves a settling time of 70 ns to 0.01%, with a low input offset voltage of 2 mV max. The AD826 is available in small 8-lead plastic mini-DIP and SO packages.
上传时间： 2020-04-19
上传用户：su1254
transimpedance linearization circuitry. This allows it to drive video loads with excellent differential gain and phase perfor mance on only 50 mW of power. The AD8001 is a current feedback amplifier and features gain flatness of 0.1 dB to 100 MHz while offering differential gain and phase error of 0.01% and 0.025°. This makes the AD8001 ideal for professional video electronics such as cameras and video switchers. Additionally, the AD8001’s low distortion and fast settling make it ideal for buffer high-speed A-to-D converters. The AD8001 offers low power of 5.5 mA max (VS = ±5 V) and can run on a single +12 V power supply, while being capable of delivering over 70 mA of load current. These features make this amplifier ideal for portable and battery-powered applications where size and power are critical. The outstanding bandwidth of 800 MHz along with 1200 V/µs of slew rate make the AD8001 useful in many general purpose high-speed applications where dual power supplies of up to ±6 V and single supplies from 6 V to 12 V are needed. The AD8001 is available in the industrial temperature range of –40°C to +85°C.
上传时间： 2020-04-21
上传用户：su1254
