算法导论 英文版 电子书 Introduction to algorithme
标签： Introduction algorithme to 算法
上传时间： 2015-05-03
上传用户：gxmm
WSP is an HTTP to WSP proxy that can be used to forward HTTP requests to WSP, which is used in WAP 1.x. It may be called a reverse WAP gateway, and enables you to test or browse WAP sites with HTTP tools. It also can be used with penetration test tools.
上传时间： 2013-12-16
上传用户：大三三
pic mcu code:This application note describes the design and implementation of a USB Mass Storage Device (MSD) using a Secure Digital card, which should prove useful to developers of USB mass storage solutions. This application may be used as a stand-alone MSD or as a Secure Digital/Multimedia Card (SD/MMC) reader/ writer interface.
标签： implementation application describes Storage
上传时间： 2014-11-23
上传用户：天诚24
This project is created using the Keil ARM CA Compiler. The Logic Analyzer built into the simulator may be used to monitor and display any variable or peripheral I/O register. It is already configured to show the PWM output signal on PORT3.0 and PORT3.1 This ARM Example may be debugged using only the uVision Simulator and your PC--no additional hardware or evaluation boards are required. The Simulator provides cycle-accurate simulation of all on-chip peripherals of the ADuC7000 device series. You may create various input signals like digital pulses, sine waves, sawtooth waves, and square waves using signal functions which you write in C. Signal functions run in the background in the simulator within timing constraints you configure. In this example, several signal functions are defined in the included Startup_SIM.INI file.
标签： the Analyzer Compiler project
上传时间： 2013-12-19
上传用户：Yukiseop
This ZIP file contains the support files for programming the Infineon C167CR CAN interface. Refer to Application Note 115a for details of this example code.
标签： programming the interface Infineon
上传时间： 2013-12-11
上传用户：2404
This ZIP file contains the support files for programming the Infineon C167CR CAN interface. Refer to Application Note 115a for details of this example code. this is part 2
标签： programming the interface Infineon
上传时间： 2014-12-03
上传用户：lixinxiang
This example project shows how to use the Idle Power-Saving Mode of the 8051Fx.
标签： Power-Saving the example project
上传时间： 2015-05-04
上传用户：weixiao99
How to Use Tables With the JTable (in the API reference documentation) class you can display tables of data, optionally allowing the user to edit the data. JTable doesn t contain or cache data it s simply a view of your data. Here s a picture of a typical table displayed within a scroll pane
标签： documentation the reference display
上传时间： 2013-12-23
上传用户：ayfeixiao
The code is fairly straightforward, except perhaps for the call to convertColumnIndexToModel. That call is necessary because if the user moves the columns around, the view s index for the column doesn t match the model s index for the column. For example, the user might drag the Vegetarian column (which the model considers to be at index 4) so it s displayed as the first column — at view index 0. Since prepareRenderer gives us the view index, we need to translate the view index to a model index so we can be sure we re dealing with the intended column
标签： convertColumnIndexToModel straightforward perhaps fairly
上传时间： 2013-12-10
上传用户：it男一枚
Shows how to use all list selection modes, using a list selection listener that s shared between a table and list.
标签： selection list listener between
上传时间： 2015-05-04
上传用户：jichenxi0730
