虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

Digit-SERIal

  • fpga/CPLD开发管理Digit-SERIal DSP Functions

    fpga/CPLD开发管理Digit-SERIal DSP Functions

    标签: Digit-SERIal Functions fpga CPLD

    上传时间: 2013-08-30

    上传用户:lz4v4

  • fpga/CPLD开发管理Digit-SERIal DSP Functions

    fpga/CPLD开发管理Digit-SERIal DSP Functions

    标签: Digit-SERIal Functions fpga CPLD

    上传时间: 2014-01-11

    上传用户:tyler

  • 脉动乘法器:一个GF(2m)域上的Digit-SERIal 脉动结构(Systolic)的乘法器

    脉动乘法器:一个GF(2m)域上的Digit-SERIal 脉动结构(Systolic)的乘法器

    标签: Digit-SERIal Systolic 脉动 乘法器

    上传时间: 2014-11-24

    上传用户:youth25

  • VIP专区-嵌入式/单片机编程源码精选合集系列(69)

    VIP专区-嵌入式/单片机编程源码精选合集系列(69)资源包含以下内容:1. vxworks下ospf协议栈.2. vxworks下的bridge协议栈.3. vxworks下radius协议栈 的源代码.4. 一份很好的ARM开发原理图.5. STR710串口测试程序.6. STR710的ADS下的测试程序.7. eboot源码.8. 用REDBOOT引导WINCE的说明.9. use of NIOS PIO to simulate I2C bus,to initial TVP5150.10. 数字钟原理图 数字钟原理图 数字钟原理图 数字钟原理图.11. 数字万用表芯片MAX134的驱动,包括一些资料,知识源于网络.12. 这是一称的项目原文件,包括T9汉字输入,打印机,24C512,已经引用到产品上.13. msp430F435做的医疗器械,包括语音模块,知识源于网络.14. 针对ARM优化过的FFT算法。其中20点.15. 采用stc12c5404ad的51系列内核无刷控制器程序.16. 很好的CPLD方面的书籍.17. 430中精确延时方法.18. 俄国佬的基于LM1875 20W吉他音箱的原理图和PCB.19. 语音控制小车电路设计原理图.20. 此为本人今期一个项目的部分C51源程序.21. 这是一个MINITGUI2。0的应用程序.22. 本程序提供了经典PID算法的优化算法.23. ucosII在arm920T内核s3c2410移植的代码..24. s3c2410的Nandflash的bootloader,参考wince的boot.25. s3c2410上移植ucos,并在ucos下实现iis音频功能.26. 立宇泰44B0所有测试源代码.27. BANYANII,JTAG SERVER,可以用WIGGLER调试ARM程序的软件.28. 4510U_BOOT源代码.29. 三星原厂的CE5.0bsp,包括eboot.30. 这是一个用VHDL +图形法在CPLD内部搭建的液晶显示的驱动程序。液晶是ocmj5*10系列.31. 研勤公司2440开发板的测试程序.32. 本文为采用VHDL编写的程序及报告。步骤如下:1设计三位二进制计数器程序 二:设计一驱动循环显示7位数字 2编写LED控制程序如下: 3设计采用原理图方式如下:.33. 成都理工大学基于MAXPLUS II 的设计过程报告内涵有源程序及设计过程中的调试:在文本编辑窗口中输入二进制8位优先编码器的程序; 3设计驱动显示程序如下: 5采用原理图方式设计如下: 6引角.34. Avalon_TFT_LCD是Nios系统液晶显示控制方案,供大家参考..35. 公园导游图 数据结构课程设计作业 需要的人下 功能:给出一张某公园的导游图.36. keil for arm 下的嵌入式ucos操作系统下的串口通讯例程.37. fpga/CPLD开发管理Digit-SERIal DSP Functions.38. S3C2410 原理图.39. ADI BLACKFIN BF533 的IIC驱动程序.40. I2C to serial communication code.

    标签: 机械 工程师手册

    上传时间: 2013-07-03

    上传用户:eeworm

  • Make and answer phone calls Detect tone and pulse digit from the phone line Capture Caller ID

    Make and answer phone calls Detect tone and pulse digit from the phone line Capture Caller ID Support blind transfer, single-step transfer/conference, consultation transfer/conference, hold, unhold. Control of the local phone handset, microphone and speaker of the modem Send and receive faxes Play and record on the phone line or sound card Play music in background mode Silence detection VU Meter Wave sound editor that allows your end-users to edit their own sound files. Voice recognition and voice synthesis. Full control over the serial port device ZModem file transfer utility File compression and encryption utility

    标签: phone and Capture Detect

    上传时间: 2013-11-30

    上传用户:水中浮云

  • Adding 32 KB of Serial SRAM to

    Although Stellaris microcontrollers have generous internal SRAM capabilities, certain applicationsmay have data storage requirements that exceed the 8 KB limit of the Stellaris LM3S8xx seriesdevices. Since microcontrollers do not have an external parallel data-bus, serial memory optionsmust be considered. Until recently, the ubiquitous serial EEPROM/flash device was the only serialmemory solution. The major limitations of EEPROM and flash technology are slow write speed, slowerase times, and limited write/erase endurance.Recently, serial SRAM devices have become available as a solution for high-speed dataapplications. The N256S08xxHDA series of devices, from AMI Semiconductor, offer 32 K x 8 bits oflow-power data storage, a fast Serial Peripheral Interface (SPI) serial bus, and unlimited write cycles.The parts are available in 8-pin SOIC and compact TSSOP packages.

    标签: Adding Serial SRAM 32

    上传时间: 2013-10-14

    上传用户:cxl274287265

  • Emulating a synchronous serial

    The C500 microcontroller family usually provides only one on-chip synchronous serialchannel (SSC). If a second SSC is required, an emulation of the missing interface mayhelp to avoid an external hardware solution with additional electronic components.The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using optimized SW routines with a performance up to 25KBaud in Slave Mode with half duplex transmission and an overhead less than 60% atSAB C513 with 12 MHz. Due to the implementation in C this performance is not the limitof the chip. A pure implementation in assembler will result in a strong reduction of theCPU load and therefore increase the maximum speed of the interface. In addition,microcontrollers like the SAB C505 will speed up the interface by a factor of two becauseof an optimized architecture compared with the SAB C513.Moreover, this solution lays stress on using as few on-chip hardware resources aspossible. A more excessive consumption of those resources will result in a highermaximum speed of the emulated interface.Due to the restricted performance of an 8 bit microcontroller a pin compatible solution isprovided only; the internal register based programming interface is replaced by a set ofsubroutine calls.The attached source files also contain a test shell, which demonstrates how to exchangeinformation between an on-chip HW-SSC and the emulated SW-SSC via 5 external wiresin different operation modes. It is based on the SAB C513 (Siemens 8 bit microcontroller).A table with load measurements is presented to give an indication for the fraction of CPUperformance required by software for emulating the SSC.

    标签: synchronous Emulating serial

    上传时间: 2014-01-31

    上传用户:z1191176801

  • PL2303 USB to Serial Adapter

    The PL2303 USB to Serial adapter is your smart and convenient accessory forconnecting RS-232 serial devices to your USB-equipped Windows host computer. Itprovides a bridge connection with a standard DB 9-pin male serial port connector inone end and a standard Type-A USB plug connector on the other end. You simplyattach the serial device onto the serial port of the cable and plug the USB connectorinto your PC USB port. It allows a simple and easy way of adding serial connectionsto your PC without having to go thru inserting a serial card and traditional portconfiguration.This USB to Serial adapter is ideal for connecting modems, cellular phones, PDAs,digital cameras, card readers and other serial devices to your computer. It providesserial connections up to 1Mbps of data transfer rate. And since USB does not requireany IRQ resource, more devices can be attached to the system without the previoushassles of device and resource conflicts.Finally, the PL-2303 USB to Serial adapter is a fully USB Specification compliantdevice and therefore supports advanced power management such as suspend andresume operations as well as remote wakeup. The PL-2303 USB Serial cable adapteris designed to work on all Windows operating systems.

    标签: Adapter Serial 2303 USB

    上传时间: 2013-11-01

    上传用户:ghostparker

  • Windows Standard Serial Communications Library for Delphi是基于WINDOWS API的串口通讯库。包括28个函数以及MODEM控制

    Windows Standard Serial Communications Library for Delphi是基于WINDOWS API的串口通讯库。包括28个函数以及MODEM控制,ANSI模拟,ASCII/XMODEM/YMODEM协议,还有14个例子程序。

    标签: Communications Standard Windows Library

    上传时间: 2013-12-25

    上传用户:王者A

  • MSComm 控件通过串行端口(serial port)传送和接收数据,为应用程序提供了串行通讯功能。而且在可视化编程盛行的今天

    MSComm 控件通过串行端口(serial port)传送和接收数据,为应用程序提供了串行通讯功能。而且在可视化编程盛行的今天,可以很方便的在Visual Basic(VB)、Visual C++(VC)、Delphi等语言及开发平台中应用。

    标签: MSComm serial port 控件

    上传时间: 2015-01-10

    上传用户:Breathe0125