虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

DEbugger

DEbugger为一种调试软件,工程师或程序员可以用来验证算法。
  • CEPARK ULINK2的仿真设置手册

    **对于CEPARK实验平台选择Debug选项卡,如图进行设置。1)选择Debug选项卡2)勾选上use千的选择框,型号选择ULINK2/MCortex DEbugger3)勾选如图所示两项4)勾选如图所示四个选项。5)设置完毕后点击settings.

    标签: cepark

    上传时间: 2022-02-15

    上传用户:

  • DAC8568驱动程序

    This example shows how you can use signal functions in the VisionDEbugger to simulate a signal that is coming into one of the analog inputs of the LPC21xx.The Measure example is described in detail in the Getting StartedUser's Guide.The MEASURE  example program is available for several targets:Simulator: uVision Simulator for LPC2129MCB2100:   Keil MCB2100 evaluation board with ULINK DEbugger           - Application is loaded to internal Flash.           - Switch S2 (INT1) is used as GPIO and sampled             (jumper positions: J1= off, J7= on)           - potentiometer POT1 is sampled as AIN0             (jumper position: J2= on)           - serial port COM1 parameters: 9600 baud, no parity,             8-bits, 1 stop bit, flow control noneMCB2130:   Keil MCB2130 evaluation board with ULINK DEbugger           - Application is loaded to internal Flash.           - Switch S2 (INT1) is used as GPIO and sampled             (jumper positions: J1= off, J7= on)           - potentiometer POT1 is sampled as AIN1             (jumper position: J2= on)           - serial port COM1 parameters: 9600 baud, no parity,             8-bits, 1 stop bit, flow control none

    标签: dac8568

    上传时间: 2022-06-28

    上传用户: