This package contains assembly programs for testing how many clock Cycles a piece of code takes to execute.
标签： contains assembly programs package
上传时间： 2013-11-25
上传用户：asdfasdfd
Edge Disjoint Cycles. You are given an input graph that is either directed or undirected. Write a program that reads in a vertex number and lists the number of edge disjoint Cycles that start and end at this vertex. The output should also list the edges in each of the cycle discovered. Input will be the adjacency matrix preceded by a 0 or 1 representing Directed or Undirected graphs respectively.
标签： undirected Disjoint directed Cycles
上传时间： 2017-04-08
上传用户：13188549192
Utils and test SD card read write Cycles
上传时间： 2017-04-29
上传用户：小草123
Industrial systems demand semiconductors that are precise, flexibleand reliable. Linear Technology offers a broad line of high performanceanalog ICs that simplify system design with rugged devices featuringparameters fully guaranteed over the -40°C to 85°C temperature range.We back this up with knowledgeable applications support, long productlife Cycles and superior on-time delivery.
上传时间： 2013-11-02
上传用户：xiaodu1124
高的工作电压高达100V N双N沟道MOSFET同步驱动 The D810DCDC is a synchronous step-down switching regulator controller that can directly step-down voltages from up to 100V, making it ideal for telecom and automotive applications. The D810DCDC uses a constant on-time valley current control architecture to deliver very low duty Cycles with accurate cycle-by-cycle current limit, without requiring a sense resistor. A precise internal reference provides 0.5% DC accuracy. A high bandwidth (25MHz) error amplifi er provides very fast line and load transient response. Large 1Ω gate drivers allow the D810DCDC to drive multiple MOSFETs for higher current applications. The operating frequency is selected by an external resistor and is compensated for variations in VIN and can also be synchronized to an external clock for switching-noise sensitive applications. Integrated bias control generates gate drive power from the input supply during start-up and when an output shortcircuit occurs, with the addition of a small external SOT23 MOSFET. When in regulation, power is derived from the output for higher effi ciency.
上传时间： 2013-10-24
上传用户：wd450412225
The LTC®3610 is a high power monolithic synchronousstep-down DC/DC regulator that can deliver up to 12Aof continuous output current from a 4V to 24V (28Vmaximum) input supply. It is a member of a high currentmonolithic regulator family (see Table 1) that featuresintegrated low RDS(ON) N-channel top and bottomMOSFETs. This results in a high effi ciency and highpower density solution with few external components.This regulator family uses a constant on-time valleycurrent mode architecture that is capable of operatingat very low duty Cycles at high frequency and with veryfast transient response. All are available in low profi le(0.9mm max) QFN packages.
上传时间： 2013-11-07
上传用户：moerwang
Although Stellaris microcontrollers have generous internal SRAM capabilities, certain applicationsmay have data storage requirements that exceed the 8 KB limit of the Stellaris LM3S8xx seriesdevices. Since microcontrollers do not have an external parallel data-bus, serial memory optionsmust be considered. Until recently, the ubiquitous serial EEPROM/flash device was the only serialmemory solution. The major limitations of EEPROM and flash technology are slow write speed, slowerase times, and limited write/erase endurance.Recently, serial SRAM devices have become available as a solution for high-speed dataapplications. The N256S08xxHDA series of devices, from AMI Semiconductor, offer 32 K x 8 bits oflow-power data storage, a fast Serial Peripheral Interface (SPI) serial bus, and unlimited write Cycles.The parts are available in 8-pin SOIC and compact TSSOP packages.
上传时间： 2013-10-14
上传用户：cxl274287265
特点 精确度0.1%滿刻度 ±1位數 可量測 交直流電流/交直流电压/電位計/傳送器/Pt-100/荷重元/電阻 等信号 显示范围-1999-9999可任意规划 具有异常值与异常次数记录保留功能 异常信号过高或过低或范围內或范围外检测可任意設定 报警继电器复归方式可任意設定 尺寸小,穩定性高 2.主要規格 精确度: 0.1% F.S. ±1 digit 0.2% F.S. ±1 digit(AC) 取样时间: 16 Cycles/sec. 显示值范围: -1999 - +9999 digit adjustable 启动延迟动作时间: 0-99.9 second adjustable 继电器延迟动作时间: 0-99.9 second adjustable 继电器复归方式: Manual (N) / latch(L) can be modified 继电器动作方向: HI /LO/GO/HL can be modified 继电器容量: AC 250V-5A, DC 30V-7A 过载显示: "doFL" 温度系数: 50ppm/℃ (0-50℃) 显示幕: Red high efficiency LEDs high 14.22mm(.56")(PV) Red high efficiency LEDs high 7.0mm(.276")(NO) 参数设定方式: Touch switches 记忆型式 : Non-volatile E2PROM memory 绝缘耐压能力: 2KVac/1 min. (input/output/power) 1600Vdc(input/output 使用环境条件 : 0-50℃(20 to 90% RH non-condensed) 存放环境条件: 0-70℃(20 to 90% RH non-condensed) CE认证: EN 55022:1998/A1:2000 Class A EN 61000-3-2:2000 EN 61000-3-3:1995/A1:2001 EN 55024:1998/A1:2001
上传时间： 2013-11-02
上传用户：fandeshun
特点 精确度0.05%满刻度 ±1位数 显示范围-19999-99999可任意规划 可直接量測直流4至20mA電流,無需另接輔助電源 尺寸小(24x48x50mm),穩定性高 分离式端子,配线容易 CE 认证 主要規格 辅助电源: None 精确度: 0.05% F.S. ±1 digit(DC) 输入抗阻: approx. 250 ohm with 20mA input 输入电压降: max. DC5V with 20mA input 最大过载能力: < ±50mA 取样时间: 2.5 Cycles/sec. 显示值范围: -19999 - 99999 digit adjustable 归零调整范围: -999-999 digit adjustable 最大值调整范围: -999-999 digit adjustable 过载显示: " doFL " or "-doFL" 极性显示: " 一 " for negative readings 显示幕 : Brigh Red LEDs high 8.6mm(.338") 温度系数 : 50ppm/℃ (0-50℃) 参数设定方式: Touch switches 记忆型式: Non-volatile E2 外壳材料: ABS 绝缘耐压能力: 2KVac/1 min. (input/case) 使用环境条件: 0-50℃(20 to 90% RH non-condensed) 存放环境条件: 0-70℃(20 to 90% RH non-condensed) 外型尺寸: 24x48x50mm CE认证: EN 55022:1998/A1:2000 Class A EN 61000-3-2:2000 EN 61000-3-3:1995/A1:2001 EN 55024:1998/A1:2001
上传时间： 2013-10-09
上传用户：lhuqi
特点 精确度0.1%满刻度 ±1位数 显示范围-19999-99999可任意规划 可直接量测直流电流/直流电压,无需另接辅助电源 尺寸小(24x48x50mm),稳定性高 分离式端子,配线容易 CE 认证 2.主要規格 辅助电源: None 精确度: 0.1% F.S. ±1 digit(1-100%F.S.) 输入抗阻 : >100Mohm(<2V range) >2Mohm(<2Vrange) < 0.25VA(current ranges) < 1000Vrms(>54V ranges) 最大过载能力: < 150Vrms(<54V ranges)
上传时间： 2013-10-08
上传用户：tiantwo
