CHAPTER 1: THE OP AMP CHAPTER 2: OTHER LINEAR CircuitS CHAPTER 3: SENSORS CHAPTER 4: RF/IF CircuitS CHAPTER 5: FUNDAMENTALS OF SAMPLED DATA SYSTEMS CHAPTER 6: CONVERTERS CHAPTER 7: DATA CONVERTER SUPPORT CircuitS CHAPTER 8: ANALOG FILTERS CHAPTER 9: POWER MANAGEMENT CHAPTER 10: PASSIVE COMPONENTS CHAPTER 11: OVERVOLTAGE EFFECTS ON ANALOG INTEGRATED CircuitS CHAPTER 12: PRINTED Circuit BOARD (PCB) DESIGN ISSUES CHAPTER 13: DESIGN DEVELOPMENT TOOLS
上传时间： 2021-12-21
上传用户：wangshoupeng199
黑金CYCLONE4 EP4CE6F17C8 FPGA开发板ALTIUM设计硬件工程（原理图+PCB+AD集成封装库）,Altium Designer 设计的工程文件，包括完整的原理图及PCB文件，可以用Altium(AD)软件打开或修改，可作为你产品设计的参考。集成封装器件型号列表：Library Component Count : 50Name Description----------------------------------------------------------------------------------------------------1117-3.3 24LC04B_0 4148 BAV99 CAP NP_Dup2CAP NP_Dup2_1 CAP NP_Dup2_2CP2102_0 C_Dup1 C_Dup1_1C_Dup2 C_Dup3 C_Dup4 C_Dup4_1 Circuit Breaker Circuit BreakerConnector 15 Receptacle Assembly, 15-Pin, Sim Line ConnectorDS1302_8SO EC EP4CE6F17C8 Cyclone IV Family FPGA, 2V Core, 179 I/O Pins, 2 PLLs, 256-Pin FBGA, Speed Grade 8, Commercial GradeEP4CE6F17C8_1 Cyclone IV Family FPGA, 2V Core, 179 I/O Pins, 2 PLLs, 256-Pin FBGA, Speed Grade 8, Commercial GradeFuse 2 FuseHEX6HY57651620/SO_0 Header 2 Header, 2-PinHeader 9X2 Header, 9-Pin, Dual rowINDUCTOR JTAG-10_Dup1 KEYB LED LED_Dup1 M25P16-VMN3PB 16 Mb (x1) Automotive Serial NOR Flash Memory, 75 MHz, 2.7 to 3.6 V, 8-pin SO8 Narrow (MN), TubeMHDR2X20 Header, 20-Pin, Dual rowMiniUSBB OSCPNP R RESISTOR RN RN_Dup1 R_Dup1 R_Dup2 R_Dup3 R_Dup5R_Dup6 SD SPEAKERSRV05-4SW KEY-DPDT ZTAbattery
标签： 黑金 cyclone4 ep4ce6f17c8 fpga
上传时间： 2021-12-22
上传用户：
一个学电子工程必备书籍，书里面介绍的很全，适用于出国党，而且做科研有一些资料可以参考
上传时间： 2022-02-09
上传用户：
The PW4554 is a cost-effective, fully integrated high input voltage single-cell Li-ion battery charger.The charger uses a CC/CV charge profile required by Li-ion battery. The charger accepts an inputvoltage up to 24V but is disabled when the input voltage exceeds the OVP threshold, typically 6.8V,to prevent excessive power dissipation. The 24V rating eliminates the over-voltage protection Circuitrequired in a low input voltage charger
标签： pw4554
上传时间： 2022-02-11
上传用户：
PW4203 is a 4.5-22V input, 2A multi-cell synchronous Buck Li-Ion battery charger, suitable forportable application. Select pin is convenient for multi-cell charging. 800 kHz synchronous buckregulator integrates of 22V rating FETs with ultra low on- resistance to achieve high efficiency andsimple Circuit design.The PW4203 is available in an 8-pin SOP package, provides a very compact system solution andgood thermal conductance
标签： pw4203
上传时间： 2022-02-11
上传用户：
The PW2606B is a front-end over voltage and over current protection device. It achieves wide inputvoltage range from 2.5VDC to 40VDC. The over voltage threshold can be programmed externally orset to internal default setting. The low resistance of integrated power path nFET switch ensures betterperformance for battery charging system applications. It can deliver up to 1A current to satisfy thebattery supply system. It integrates the over-temperature protection shutdown and auto-recoveryCircuit with hysteresis to protect against over current events
标签： pw2606b
上传时间： 2022-02-11
上传用户：
The PW2601 is a charger front-end integrated Circuit designed to provide protection to Li-ionbatteries from failures of charging Circuitry. The device monitors the input voltage, battery voltageand the charging current to make sure all three parameters are operated in normal range. Thedevice will switch off internal MOSFET to disconnect IN to OUT to protect load when any of inputvoltage, output current exceeds the threshold. The Over temperature protection (OTP) functionmonitors chip temperature to protect the device. The PW2601 also can protect the system’sbattery from being over charged by monitors the battery voltage continuously. The deviceoperates like a linear regulator, maintaining a 5.1V output with input voltages up to the input overvoltage threshold.The PW2601 is available in DFN-2x2-8L package. Standard products are Pb-free and Halogenfree
标签： pw2601
上传时间： 2022-02-11
上传用户：
The PW2202 is silicon N-channel Enhanced VDMOSFETs, is obtained by the self-aligned planarTechnology which reduce the conduction loss, improve switching performance and enhance theavalanche energy. The transistor can be used in various power switching Circuit for system
标签： pw2202
上传时间： 2022-02-11
上传用户：默默
Agilent 34401A Service Guide.pdfIEC Measurement Category II includes electrical devices connected to mains at an outlet on a branch Circuit. Such devices include most small appliances, test equipment, and other devices that plug into a branch outlet or socket. The 34401A may be used to make measurements with the HI and LO inputs connected to mains in such devices, or to the branch outlet itself (up to 300 VAC). However, the 34401A may not be used with its HI and LO inputs connected to mains in permanently installed electrical devices such as the main Circuit-breaker panel, sub-panel disconnect boxes, or permanently wired motors. Such devices and Circuits are subject to overvoltages that may exceed the protection limits of the 34401A. Note: Voltages above 300 VAC may be measured only in Circuits that are isolated from mains. However, transient overvoltages are also present on Circuits that are isolated from mains. The Agilent 34401A are designed to safely withstand occasional transient overvoltages up to 2500 Vpk. Do not use this equipment to measure Circuits where transient overvoltages could exceed this level. Additional Notices Waste Electrical and Electronic Equipment (WEEE) Directive 2002/96/EC This product complies with the WEEE Directive (2002/96/EC) marking requirement. The affixed product label (see below) indicates that you must not discard this electrical/electronic product in domestic household waste. Product Category: With reference to the equipment types in the WEEE directive Annex 1, this product is classified as a "Monitoring and Control instrumentation" product. Do not dispose in domestic household waste. To return unwanted products, contact your local Agilent office, or see www.agilent.com/environment/product for more information. Agilent 34138A Test Lead Set The Agilent 34401A is compatible with the Agilent 34138A Test Lead Set described below. Test Lead Ratings Test Leads - 1000V, 15A Fine Tip Probe Attachments - 300V, 3A Mini Grabber Attachment - 300V, 3A SMT Grabber Attachments - 300V, 3A Operation The Fine Tip, Mini Grabber, and SMT Grabber attachments plug onto the probe end of the Test Leads. Maintenance If any portion of the Test Lead Set is worn or damaged, do not use. Replace with a new Agilent 3413
标签： agilent
上传时间： 2022-02-20
上传用户：
本书的核心内容是关于半导体器件和有源电路的模拟电子电路基础。两位作者Robert L．Boylestad和Louis Nashelsky都是在大学从事电路分析、电子电路基础等相关学科教学的资深教授，在电子电路学科领域出版了多部优秀教材，受到很高的评价。本书自1972年首次出版至今已经修订至第九版，涵盖了更广泛和新颖的内容，成为流行30多年的优秀经典教材。这本改编版在第九版原版内容的基础上，结合国内高等教育中模拟电子电路课程的特点，进行了部分内容的调整。 内容提要 本书是英文原版教材Electronic Devices and Circuit Theory,Ninth．Edition之英文改编版《模拟电子技术》的翻译版，内容包括半导体器件基础、二极管及其应用电路、晶体管和场效应管放大电路的基本原理及频率响应、功率放大电路、多级放大电路、差分放大电路、电流源等模拟集成电路的单元电路、反馈电路、模拟集成运算放大器、电压比较器和波形变换电路等。本书对原版教材进行了改编，精简了内容，突出了重点，补充了必要知识点，内容更加新颖和系统化，反映了器件和应用的发展趋势，强调了系统工程的概念。 本书与英文版教材配套使用，适合电子、计算机、通信等相关专业电子电路基础课程40学时到68学时的中文或双语教学要求，也可供相关专业工程技术人员的学习和参考。
标签： 模拟电子
上传时间： 2022-03-21
上传用户：
