虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

ADJUSTABLE

  • A fast customizable function for locating and measuring the peaks in noisy time-series signals. Adju

    A fast customizable function for locating and measuring the peaks in noisy time-series signals. ADJUSTABLE parameters allow discrimination of "real" signal peaks from noise and background. Determines the position, height, and width of each peak by least-squares curve-fitting.

    标签: customizable time-series measuring function

    上传时间: 2015-08-10

    上传用户:invtnewer

  • Software uart using a general purpose io and an external interrupt pin of an atmel uc. half duplex o

    Software uart using a general purpose io and an external interrupt pin of an atmel uc. half duplex operation, ADJUSTABLE baud rate

    标签: interrupt Software external general

    上传时间: 2013-12-31

    上传用户:zhangyigenius

  • MAX1771

    12V or ADJUSTABLE, High-Efficiency,Low IQ, Step-Up DC-DC Controller

    标签: 1771 MAX

    上传时间: 2016-10-20

    上传用户:oyjwle

  • AP2406技术手册

    The AP2406 is a 1.5Mhz constant frequency, slope compensated current mode PWM step-down converter. The device integrates a main switch and a synchronous rectifier for high efficiency without an external Schottky diode. It is ideal for powering portable equipment that runs from a single cell lithium-Ion (Li+) battery. The AP2406 can supply 600mA of load current from a 2.5V to 5.5V input voltage. The output voltage can be regulated as low as 0.6V. The AP2406 can also run at 100% duty cycle for low dropout operation, extending battery life in portable system. Idle mode operation at light loads provides very low output ripple voltage for noise sensitive applications. The AP2406 is offered in a low profile (1mm) 5-pin, thin SOT package, and is available in an ADJUSTABLE version and fixed output voltage of 1.2V, 1.5V and 1.8V

    标签: 2406 AP 技术手册

    上传时间: 2017-02-23

    上传用户:w124141

  • AZ1117H

    The AZ1117 is a series of low dropout three-terminal regulators with a dropout of 1.15V at 1A output current. The AZ1117 series provides current limiting and thermal shutdown. Its circuit includes a trimmed bandgap reference to assure output voltage accuracy to be within 1% for 1.5V, 1.8V, 2.5V, 2.85V, 3.3V, 5.0V and ADJUSTABLE versions or 2% for 1.2V version. Current limit is trimmed to ensure specified output current and controlled short-circuit current. On-chip thermal shutdown provides protection against any combination of overload and ambient temperature that would create excessive junction temperature.  The AZ1117 has an ADJUSTABLE version, that can provide the output voltage from 1.25V to 12V with only 2 external resistors.

    标签: 1117H 1117 AZ

    上传时间: 2019-04-11

    上传用户:heaven0o0o0

  • SC3633

    Wide 2.2V to 6V Input Voltage Range „ 0.20V FB ADJUSTABLE LED drive current „ Directly drive 9 Series 1W LED at VIN>=6V „ Fixed 800KHz Switching Frequency „ Max. 3A Switching Current Capability „ Up to 92% efficiency „ Excellent line and load regulation „ EN PIN TTL shutdown capability „ Internal Optimize Power MOSFET

    标签: sc3633

    上传时间: 2021-11-05

    上传用户:d1997wayne

  • PW2053-2.0.pdf规格书

    The PW2053 is a high-efficiency monolithic synchronous buck regulator using a constantfrequency, current mode architecture. The device is available in an ADJUSTABLE version. Supply currentwith no load is 40uA and drops to <1uA in shutdown. The 2.5V to 5.5V input voltage range makesthe PW2053 ideally suited for single Li-Ion battery powered applications. 100% duty cycle provideslow dropout operation, extending battery life in portable systems. PWM/PFM mode operationprovides very low output ripple voltage for noise sensitive applications. Switching frequency isinternally set at 1.2MHz, allowing the use of small surface mount inductors and capacitors. Lowoutput voltages are easily supported with the 0.6V feedback reference voltage

    标签: pw2053

    上传时间: 2022-02-14

    上传用户:jason_vip1

  • 步进电机驱动器原理图+PCB+驱动源码+使用教程等

    该步进电机驱动器又称为EasyDriver,EasyDriver能够为两级步进电机提供大约每相750mA(两极一共1.5A)的驱动。它默认设置为8步细分模式(所以如果你的电机是每圈200步,你使用EasyDriver时默认为每圈1600步),更多细分模式可以通过将MS1或MS2两个接脚接地进行设置。这是一种基于Allegro A3967驱动芯片的细分断路器。对于此设计的完整规格,请查阅A3967的参数表。它的最大每相电流从150mA到750mA。可以采用的最大驱动电压大概是30V,其中包括板载5V的调压器,所以只需要一个电源。质优价廉,这玩意儿只要十几美元,比你自己制作电路板更便宜。步进电机驱动器设计特色:· A3967 Microstepping Driver· MS1 and MS2 pins broken out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth)· Compatible with 4, 6, and 8 wire stepper motors of any voltage· ADJUSTABLE current control from 150mA/phase to 700mA/phase· Power supply range from 6V to 30V. The higher the voltage, the higher the torque at high speeds

    标签: 步进电机 驱动器 pcb 驱动

    上传时间: 2022-04-27

    上传用户: