Bootloading the TMS320VC5506/C5507/C5509 A digital signal processor (DSP) through the on-chip universal serial bus (USB) peripheral is part of the standard bootloader provided on the device. This document describes the procedures for physically connecting the DSP to a USB host, invoking the USB bootloader on the DSP, generating the correct boot table file, and downloading the boot table from the host to the DSP via USB.
标签： Bootloading the processor digital
上传时间： 2017-02-11
上传用户：脚趾头
DSP算法 SMOOTH: CONVOLVES A MATRIX WITH A 3X3 GAUSSIAN FILTER KERNEL
标签： CONVOLVES GAUSSIAN SMOOTH MATRIX
上传时间： 2013-12-22
上传用户：BIBI
TMS320C55x DSP Programmer s Guide (Rev. A).pdf
标签： Programmer Guide 320C TMS
上传时间： 2017-02-24
上传用户：集美慧
程序所在目录：ex6_AD 板上引出的两路A/D 转换对应DSP 的A/D 模块分别是通道0 和通道8，输入电压0-5V 。 本开发板使用DA 的输出作为AD 的输入，因此需将5J2 的1-2，3-4 分别用短路子短接。 打开CC2000,进行如下操作： 1．Project->Open ，打开该目录中的工程文件。 2．Project->Rebuild ALL,编译链接 3．File->Load Program 4．光标移到Que()函数的asm(" NOP ")所处的行。 5． Debug->Toggle breakpoint （快捷键F9） 6． Debug->Animate （快捷键F12） 7． View->Watch Window ，在出现的watch 窗体中点右键分别插入变量AD_SIG0,AD_SIG8，则可看到所采到的这两路信号的电压值。 如果结果稍微不精确，请不要在意，这可能是因为没有采用专用基准源，以及信号不稳定的缘故。另外,TMS320LF2407 的内置A/D 的精度并不是很高。在前面两种情况已得到保证的情况下，变化幅度仍较大。（ ^_^ 呵呵，外面好一点的一片A/D 芯片就不低于100 块，所以想想能凑合着用也就可以了。）
上传时间： 2013-12-17
上传用户：refent
this helps u a lot in dsp
上传时间： 2013-12-29
上传用户：onewq
In C Algorithms for Real-Time DSP, author Paul M. Embree presents a complete guide to digital signal processing techniques in the C programming language. This book is structured in such a way that it will be most useful to the engineer who is familiar with DSP and the C language, but who is not necessarily an expert in both. All of the example programs in this book have been tested using standard C compilers in the UNIX and MS-DOS programming environments. In addition, the examples have been compiled using the real-time programing tools of specific real-time embedded DSP microprocessors (Analog Devices ADSP-21020 and ADSP-21062 Texas Instruments TMS320C30 and TMS320C40 and AT&T DSP32C) and then tested with real-time hardware using real-world signals.
标签： M. Algorithms Real-Time complete
上传时间： 2014-01-07
上传用户：epson850
A GPIO(General Purpose Input Output) example source code for TI TMS320F2812 DSP
标签： General Purpose example Output
上传时间： 2013-12-17
上传用户：stella2015
DSP并行读取串行接口A/D芯片的VHDL接口程序
上传时间： 2017-08-10
上传用户：zhuimenghuadie
this is a license file for visual dsp.
上传时间： 2014-01-07
上传用户：eclipse
It was tested on a XESS XCV800 board interfacing to a proprietary device with a TI DSP, exchanging PCM streams in both directions.
标签： interfacing proprietary exchanging tested
上传时间： 2013-12-25
上传用户：nanshan
