用fpga+usb显现的4通道800K的数据采集方案。
上传时间： 2013-08-10
上传用户：moshushi0009
用fpga+usb显现的4通道800K的数据采集方案。
上传时间： 2013-12-20
上传用户：fxf126@126.com
//*** *** *** *** *** *** *** *** *** *** *** *** *** * // MSP-FET430x110 Demo - Software Toggle P1.0 // // Description: Toggle P1.0 by xor ing P1.0 inside of a software loop. // ACLK = n/a, MCLK = SMCLK = default DCO ~800K // // MSP430F1121 // ----------------- // /|\| XIN|- // | | | // --|RST XOUT|- // | | // | P1.0|-->LED // // M. Buccini // Texas Instruments Inc. // Feb 2005 // Built with IAR Embedded Workbench Version: 3.21A
标签： Software MSP-FET Toggle Demo
上传时间： 2014-01-09
上传用户：问题问题
MSP-FET430P410 Demo - Timer_A Toggle P5.1, CCR0 Contmode ISR, DCO SMCLK Description Toggle P5.1 using using software and TA_0 ISR. Toggle rate is set at 50000 DCO/SMCLK cycles. Default DCO frequency used for TACLK. Durring the TA_0 ISR P5.1 is toggled and 50000 clock cycles are added to CCR0. TA_0 ISR is triggered exactly 50000 cycles. CPU is normally off and used only durring TA_ISR. ACLK = n/a, MCLK = SMCLK = TACLK = DCO ~ 800K
标签： Toggle Description 5.1 Contmode
上传时间： 2014-01-04
上传用户：gut1234567
D169 Demo - DMA0 Repeated Burst to-from RAM, Software Trigger Description A 32 byte block from 220h-240h is transfered to 240h-260h using DMA0 in a burst block using software DMAREQ trigger. After each transfer, source, destination and DMA size are reset to inital software setting because DMA transfer mode 5 is used. P1.0 is toggled durring DMA transfer only for demonstration purposes. ** RAM location 0x220 - 0x260 used - always make sure no compiler conflict ** ACLK= n/a, MCLK= SMCLK= default DCO ~ 800K
标签： Description Repeated Software to-from
上传时间： 2014-01-09
上传用户：thinode
宣读了一份tlc549 ADC的参考vcc使用软件SPI和存储8位数字代码在adcdata 。该tlc549采样，在一个连续循环。如果adcdata > 0.5 * vcc ， p1.0设置，否则复位。aclk为N /甲mclk = smclk =预设会计处〜 800K vcc必须至少为3V为tlc549
上传时间： 2013-12-11
上传用户：Yukiseop
