Robust stability for time-delay systems
标签： Robust stability time-delay systems
上传时间： 2015-02-15
上传用户：594428403
针对目前使用的RS232接口数字化B超键盘存在PC主机启动时不能设置BIOS，提出一种PS2键盘的设计方法。基于W78E052D单片机，采用8通道串行A/D转换器设计了8个TGC电位器信息采集电路，电位器位置信息以键盘扫描码序列形式发送，正交编码器信号通过XC9536XL转换为单片机可接收的中断信号，软件接收到中断信息后等效处理成按键。结果表明，在满足开机可设置BIOS同时，又可实现超声特有功能，不需要专门设计驱动程序，接口简单，成本低。 Abstract: Aiming at the problem of the digital ultrasonic diagnostic imaging system keyboard with RS232 interface currently used couldn?蒺t set the BIOS when the PC boot， this paper proposed a design method of PS2 keyboards. Based on W78E052D microcontroller，designed eight TGC potentiometers information acquisition circuit with 8-channel serial A/D converter， potentiometer position information sent out with keyboard scan code sequentially.The control circuit based on XC9536 CPLD is used for converting the mechanical actions of the encoders into the signals that can be identified by the MCU， software received interrupt information and equivalently treatmented as key. The results show that the BIOS can be set to meet the boot， ultrasound specific functionality can be achieved at the same time， it does not require specially designed driver，the interface is simple and low cost.
上传时间： 2013-10-10
上传用户：asdfasdfd
I. C. Wong, Z. Shen, J. G. Andrews, and B. L. Evans, ``A Low Complexity Algorithm for Proportional Resource Allocation in OFDMA Systems , Proc. IEEE Int. Work. Signal Processing Systems, 针对这篇文章给出的源代码
上传时间： 2014-01-24
上传用户：zhichenglu
随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
标签： 电流保护器
上传时间： 2022-03-27
上传用户：
21世纪大学新型参考教材系列 集成电路B 荒井
上传时间： 2013-04-15
上传用户：eeworm
家电维修(最基础的教程B)1-20.Torrent
上传时间： 2013-06-10
上传用户：eeworm
jk-b交通信号控制机原理图
上传时间： 2013-07-13
上传用户：eeworm
专辑类-实用电子技术专辑-385册-3.609G jk-b交通信号控制机原理图-1.3M.zip
上传时间： 2013-08-02
上传用户：zhf1234
专辑类-电子基础类专辑-153册-2.20G 21世纪大学新型参考教材系列-集成电路B-荒井-159页-2.8M.pdf
上传时间： 2013-05-16
上传用户：pkkkkp
三次B样条曲线源代码,C语言编写的三次B样条曲线源代码，希望大家喜欢。
标签：
上传时间： 2013-07-13
上传用户：chengli008
