推挽式单级电流源高频链逆变拓扑研究
上传时间： 2022-03-17
上传用户：fliang
随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
标签： 电流保护器
上传时间： 2022-03-27
上传用户：
配电网中,各种配电终端的电流、电压、有功功率及无功功率等模拟量的采集是配电网自动化的重要环节。这些模拟量的采集也是各种仪器和家用电器的必要功能。因此,设计了基于嵌入式STM32F103单片机的交流电压、交流电流及有功功率的采集系统,通过电压互感器TV1005M和电流互感器TA1005M分别检测交流电压和交流电流值;屏幕或者手机APP和WiFi模块互联后,可以实时显示交流电压、交流电流、功率及电量值;通过设定阈值功率,可以实现对电流的监控和对电路的保护。In the distribution network,the collection of analog,such as current,voltage,active power,and reactive power at various distribution terminals is a very important part of distribution network automation. These analog acquisitions are also for various instruments and household appliances. Very important technology. Therefore,an AC voltage,AC current and active power acquisition system based on embedded STM32 F103 machine is designed,and AC voltage and AC current values are detected by voltage transformer TV1005 M and current Transformer TA1005 M respectively;After the screen or mobile phone APP and WiFi modules are interconnected,AC voltage,AC current,power,and power values can be displayed in real time;By setting the threshold power,the current can be monitored and the circuit can be protected.
上传时间： 2022-03-27
上传用户：shjgzh
本系统基于STM32单片机设计的非接触式电流检测控制系统,通过OPA548片将所给任意信号放大,由100Ω电阻和INA128芯片进行电流电压转换放大后,利用STM32单片机对获取的电压信号以0.488μs频率采样,利用STM32单片机的FFT库,获得信号的谐波信息。测量电流信号精准,该设计可广泛应用在以STM32单片机为核心控制器件的新型仪表中,性能精准且抗干扰能力强。This system is a non-contact current detection and control system based on STM32 single chip microcomputer. It amplifiesany signal through OPA548 chip, converts and amplifies the current and voltage by 100 Ω resistance and INA128 chip. The obtainedvoltage signal is sampled at the frequency of 0.488 μs by STM 32 single chip microcomputer, and the harmonic information of the signalis obtained by the FFT library of STM 32 single chip microcomputer. The measurement of current signal is accurate. This design can bewidely used in a new instrument with STM 32 single chip microcomputer as its core control device, with accurate performance and stronganti-interference capability.
上传时间： 2022-03-27
上传用户：
本设计采用分立元件和STC15F2K60S2单片机设计出了电流信号检测仪。STC15F2K60S2单片机与采样电路和整流电路相配合,利用STC15F2K60S2单片机的A/D转换器和中断系统测量出交流电流的大小和频率,并通过OLED实时显示参数。该方案能较好地测量出交流电流的大小和频率,且电路简单,成本较低。
标签： stc15f2k60s2 单片机 电流信号检测仪
上传时间： 2022-04-03
上传用户：
电学中的测量技术涉及范围非常广,电流测量在电学计量中占有非常重要的位置。如何精确地进行电流测量是精密测量的一大难题。传统的电流检测电路多采用运算放大芯片与片外电流检测电路相结合的方式,电路集成度很低,需要较多的接口和资源才能完成对电路的检测。本文把所有电路部分都集成在一块芯片上,包括检测电阻,运算放大器电路及模拟转数字转换电路,从而在电路内部可以进行电流检测,使电路更好的集成化。前置电路使用二级共源共栅结构的运算放大器,减小沟道长度调制效应造成的电流误差。10位SAR ADC中采用电容驱动能力强的传输门保证了模数转化器的有效精度。比较器模块采用再生锁存器与迟滞比较器作为基础单元组合解决精密测量的问题。本设计可以作为嵌入芯片内的一小部分而检测芯片中的微小电流1mA~100mA,工作电压在1.8v左右,电流检测精度预期达到10uA的需求。The measurement technology in electricity involves a wide range,and current measurement plays a very important position in electrical measurement.How to accurately measure current is a big problem in precision measurement. The traditional current detecting circuit adopts the combination of the operational amplifier chip and theoff-chip current detecting circuit, The circuit integration is very low, and more interfaces and resources are needed tocomplete the circuit detection.This topic integrates all the circuit parts into one chip, including detection resistance, operational amplifier circuit andanalog to digital conversion circuit. Highly integrated circuit makes the external resources on the chip more intensive,so that current detection can be carried out inside the circuit, so that the circuit can be better integrated. Thefront-end circuit of this project uses two-stage cascade operational amplifier and cascade tube to reduce the currenterror caused by channel length modulation effect. In 10-bit SAR ADC, the transmission gate with strong capacitivedriving ability ensures the effective accuracy of the analog-to-digital converter. Comparator module uses regenerativelatch and hysteresis comparator as basic unit to solve the difficult problem of precision measurement. This topic can beused as a small part of the embedded chip to detect the micro-current in the chip 1 mA~100 mA, the working voltageis about 1.8v, and the current detection accuracy is expected to reach the requirement of 10 uA.
上传时间： 2022-04-03
上传用户：
基于MATLAB Simulink的电压电流双闭环控制的仿真，包含算法及波形。
上传时间： 2022-04-07
上传用户：
该文档为用单片机制作电池容量测试仪讲解文档，是一份很不错的参考资料，具有较高参考价值，感兴趣的可以下载看看………………
标签： 单片机
上传时间： 2022-04-08
上传用户：20125101110
数控直流电流源设计方案，有需要的可以参考！
标签： 数控直流电源
上传时间： 2022-04-12
上传用户：shjgzh
电脑ATX电源改0V-30V可调电源-电流7A(申精)
标签： 电源
上传时间： 2022-04-12
上传用户：trh505
