虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

多谐振荡器

多谐振荡器:利用深度正反馈,通过阻容耦合使两个电子器件交替导通与截止,从而自激产生方波输出的振荡器。常用作方波发生器。
  • DK4.1P-多功能数字卡拉OK处理器

    LAXDK4.1P是多功能数字处理器,所有功能都通过双DSP处理实现。独立处理芯片实现全功能的参量均衡,精确分频,输出限幅。内置一个DSP效果器,包含两个独立的可编程引擎,分别处理回声、混响效果,实现无穷的效果组合。并且提供精确快速的反馈抑制功能。3路线路输入、背景音乐(BGM)功能,并带有同步视频切换。音乐通道配置7段全参量均衡适应千变万化的应用环境。话筒通道7段全参量均衡,配合优质话放电路带来清晰干净的演唱效果。超低音分频实现斜率、滤波器、上下限频点的全部可调,并配置3段参量均衡使调试更得心应手。独立中置输出通道,输出话筒直达声,并配置3段参量均衡大大提升演唱人声的表现能力。

    标签: 4.1 DK 多功能 卡拉OK处理器

    上传时间: 2013-10-26

    上传用户:herog3

  • 工控软件组态王与单片机多机串口通讯的设计

    详细介绍工控软件组态王与单片机多机串口通讯的设计原理。分析组态王提供的直接与单片机串口通信方法的优点,给出系统基于RS-485总线传输的接口电路原理图。根据组态王提供的通讯协议和单片机多机串口通讯的原理,给出程序设计流程与思路。 Abstract:  In this paper,the design principle of communication between multi-SCM and KingView by serial ports is described in detail.We analysis the advantage of method supplied by KingView,by which KingView can communicate with serial ports of SCM directly,and provide the system’s interface circuit based on the RS-485transmission line.We provide flow diagram of programming and thinking on the basis of communication protocol supplied by KingView and principle of communication among multi-SCM through serial ports.

    标签: 工控软件 单片机 串口通讯 多机

    上传时间: 2013-12-19

    上传用户:tecman

  • 基于单片机和FPGA的多功能计数器的设计

    以89S52单片机和EP1C6Q240C8型FPGA为控制核心的多功能计数器,是由峰值检波、A/D转换、程控放大、比较整形、移相网络部分组成,可实现测量正弦信号的频率、周期和相位差的功能。多功能计数器采用等精度的测量方法,可实现频率为1Hz~10MHz、幅度为0.01~5Vrms的正弦信号的精确测频,以及频率为10Hz~100kHz、幅度为0.5~5Vrms的正弦信号精确测相。液晶显示器能够实时显示当前信号的频率、周期和相位差。该多功能计数器精度高,界面友好,实用性强。 Abstract:  A multi-function counter,which uses89S52MCU and EP1C6Q240C8FPGA as a control core,consists of peak detector,A/D conversion,program-controlled amplification,compared shaping and phase-shifting network part.The counter measures the frequency,period and phase of sinusoidal signal.With the equal precision method,the multi-function counter achieves the precise frequency measurement of the sinusoidal signal which its frequency is from1Hz to10MHz,its amplitude is from0.01Vrms to5Vrms,as well as the accurate phase measurement of the sinusoidal signal which its frequency is from10Hz to100kHz,its amplitude is from0.5Vrms to5Vrms.The LCD monitor real-time displays the frequency,period and phase difference of current signal.The multi-function counter features high precision,friendly interface,and strong practical.

    标签: FPGA 单片机 多功能 计数器

    上传时间: 2013-11-15

    上传用户:gy592333

  • 基于AT89S52单片机的多功能音乐播放器

    介绍一种多功能音乐播放器,它是以AT89S52单片机为核心,并辅有一些外围器件,采用汇编语言编写程序,实现多功能音乐播放,歌曲自动循环播放和使用琴键自编曲目功能。此外,彩灯显示歌曲节奏,按键跳转到喜爱曲目,液晶显示当前播英文曲目。并给出了系统软硬件设计。 Abstract:  It introduces a multifunctional music player,taking AT89S52 single-chip microcomputer as hardware control core and using some peripheral elements.Programmes are compiled in assembly language to act as expected.There are two functional modes in this system.One is to make the music play automatically and consecutively,the other is to compose new songs through keys.In addition,lights show the pace of music and the English names can be displayed in the liquid crystal screen.With perfect combination of hardware and software,the music player can meet many music lovers’needs for multifunctional music player.And the hardware and software of the system are given.

    标签: 89S S52 AT 89

    上传时间: 2013-11-18

    上传用户:xiaodu1124

  • 基于C8051F020单片机的多路压力测量仪

    介绍了一种基于C8051F020单片机的多路压力测量仪。该测量仪选用电阻应变式压力传感器采集压力信号,并经放大电路处理后送入C8051F020单片机,再由C8051F020单片机内部的A/D转换器将采集到的压力信号进行模数转化,然后分别对数据进行存储和显示。该测量仪能测量6路压力信号,并且各测量点都能单独检测和设置。由于采用了C8051F020单片机,简化了硬件电路,增强了抗干扰能力,使得测量仪具有测量精度高,冲击小等特点。 Abstract:  A measurement apparatus for multi-channel pressure based on single chip microcomputer is introduced.It can measure 6 channels signal of the pressure,and the pressure measure points can be detection and located individually.The pressure signal sampling is obtained by resistor stress-type pressure sensors,the digital signals of 6 channels are collected through amplifying and adjustment circuit of pressure signals and internal integrated A/D converter of MCU.Finally,and it realizes the function to store and display data separately.C8051F020 was used to made hardware circuit simple,and it also enhanced the anti-interference ability.It features high precision and little impact.

    标签: C8051F020 单片机 多路 压力

    上传时间: 2013-11-16

    上传用户:yare

  • 8位OTP单片机芯片BL35P02R

    概述 BL35P02R是一款低功耗8位OTP型微控制器单元(MCU),并带有内置高精度振荡器,及一个可直接驱动红外发射管的遥控码输出口,适用于各类家电(如电视、VCD机等)的红外遥控器。 主要特点 8位CISC结构CPU(MotorolaHC05兼容)最多可支持16个通用IO口和1个输入口1个8位定时/计数器9路键盘中断(KBI)1路遥控码输出口(IROUT),8种载波频率可选(1/3占空比),驱动能力强(>300mA)外接晶振325K-8MHz/内置RC振荡4MHz(偏差≤5%,0-40℃,2.0-3.6V工作电压范围内)低功耗设计(待机功耗<1uA@3V)32byteRAM(含堆栈)2K*8bitOTPROMOTP数据加密功能工作电压2.0-5.5V封装形式:SOP20(300mil)/SOP18(300mil)/SOP16(150mil)

    标签: 02R 35P OTP P02

    上传时间: 2013-10-12

    上传用户:z240529971

  • 多核心单片机

    公司简介 应广科技成立于2005年2月18日资本额RMB3千万台湾优良IC设计公司主要核心技术:领先全球的平行处理多核心单片机。以轫体取代硬体设计的创新技术与思维。精简的C语言编译器。97个精简指令开发容易,有效缩小程式空间提高工作效率。拥有全球数十项多核心单片机专利技术。经专业测试认证ESD达8千伏特以上。超高抗杂讯能力,超高抗干扰能力。

    标签: 多核 单片机

    上传时间: 2014-12-27

    上传用户:togetsomething

  • 80C196MC单片机实现多处理机互联技术应用

    摘要:讨论了80C196MC单片机系统多微机互联方案,该系统以单片机为主模块,共享存储器、共享I/O、总线接口及仲裁器构成。重点分析了多处理机及总线接口逻辑的实现。关键词:单片机   公共总线  多机通讯

    标签: C196 196 80C 80

    上传时间: 2013-11-03

    上传用户:璇珠官人

  • 基于MC33993的多路开关检测接口电路设计

    主要介绍了以PIC18F2480单片机为处理器,基于可编程多路开关检测接口器件MC33993实现的车用多路开关检测接口电路的设计。该设计克服了以往基于分立元件的检测接口电路的弊端,简化了接口电路设计,保证了车用开关工作的可靠性和安全性。 Abstract:  The design of automotive multiple switch detection interface circuit based on MC33993 is introduced mainly which adopts PIC18F2480 single chip microprocessor.This circuit overcomes shortage of traditional design which contains many schism elements, and the application of MC33993 also predigests the whole design of interface circuit and guarantees the dependability and security of the switch.

    标签: 33993 MC 多路开关 检测

    上传时间: 2013-11-19

    上传用户:star_in_rain

  • 多路温度采集及监控系统的设计

    介绍一种基于单片机的多路温度采集及监控系统,能够测量6路温度信号,具有计算机联网功能,各测量点可以单独监控和设置,可根据用户的需求自动控制。测量温度范围为-10 ℃~200 ℃,控制方式采用模拟量调压模式。该系统具有控制精度高、冲击小等特点。 Abstract:  A temperature collecting and surveillance-controlling system based on sing-chip microcomputer is introduced. It can measure 6 channel signal of the temperature,and it has a function of network connection.The temperature measure points can be monitored and located, it can be controlled automatic according to user’s demand.The temperature range is -10℃ to 200℃.The model of control is adjustable voltage with simulation. It features high precision and little impact.

    标签: 多路 温度采集 监控系统

    上传时间: 2013-10-23

    上传用户:bjgaofei