msp430The LDC1312 and LDC1314 are 2- and 4-channel, 1• Easy-to-use – minimal configuration required 12-bit inductance to digital converters (LDCs) for • Measure up to 4 sensors with one IC inductive sensing solutions. With multiple channels • Multiple channels support environmental and and support for remote sensing, the LDC1312 and aging compensation LDC1314 enable the performance and reliability benefits of inductive sensing to be realized at minimal• Multi-channel remote sensing provides lowest cost and power. The products are easy to use, onlysystem cost requiring that the sensor frequency be within 1 kHz • Pin-compatible medium and high-resolution and 10 MHz to begin sensing. The wide 1 kHz to 10 options MHz sensor frequency range also enables use of very small PCB coils, further reducing sensing– LDC1312/4: 2/4-ch 12-bit LDC solution cost and size.– LDC1612/4: 2/4-ch 28
上传时间： 2016-07-22
上传用户：tongmoonsky
设计功率MOSFET驱动电路时需重点考虑寄生参数对电路的影响。米勒电容作为MOSFET器件的一项重要参数,在驱动电路的设计时需要重点关注。重点观察了MOSFET的开通和关断过程中栅极电压、漏源极电压和漏源极电流的变化过程,并分析了米勒电容、寄生电感等寄生参数对漏源极电压和漏源极电流的影响。分析了栅极电压在米勒平台附近产生振荡的原因,并提出了抑制措施,对功率MOSFET的驱动设计具有一定的指导意义。When designing the drive circuit of power MOSFET,the influence of parasitic parameters on the circuit should be concerned.As an important parameter of MOSFET device,Miller capacitance should be considered in the design of drive circuit.The variation of gate voltage,drain source voltage and drain source current during the turn-on and turn-off of MOSFET were observed.The influences of parasitic parameters such as Miller capacitance and parasitic inductance on drain source voltage and drain source current were analyzed.The reasons of gate voltage oscillation nearby Miller plateau were analyzed,and the restraining measures were put forward.This research was instructive for the drive design of power MOSFET.
标签： mosfet
上传时间： 2022-04-02
上传用户：默默
为设计高效率、低损耗的PFC电路,本文基于UCC28019进行电路设计。以UCC28019输出的PWM波形来控制Boost升压斩波为核心电路,使电路中的电容交替地充放电、电感交替的储存和释放能量,最后实现在输入AC20V~24V电压情况下稳定输出DC38V。测试结果表明,系统实现效率为95%左右,电压调整率小于1%,电源功率因数0.99。交流输入电压为19.0-25.8 V时,输出直流电压稳定性较好,电感无明显啸叫且纹波小,具有一定的带负载能力和实用性。In order to design the PFC circuit with high efficiency and low loss,this paper designs the circuit based on UCC28019.The PWM waveform output by UCC28019 is used to control boost chopper as the core circuit,which alternately charges and discharges capacitors,stores and releases energy by inductors,and finally achieves stable output of DC38 V under the input voltage of AC20 V~24 V.The test results show that the system achieves about 95% efficiency,the voltage adjustment rate is less than 1%,the power factor is 0.99,and the AC input voltage is 19.0-25.8 V.The output DC voltage stability is good,the inductance has no obvious whistle and the ripple is small,so it has certain load capacity and practicability.
上传时间： 2022-04-03
上传用户：
