The C500 microcontroller family usually provides only one on-chip synchronous serialchannel (SSC). If a second SSC is required, an emulation of the missing interface mayhelp to avoid an external hardware solution with additional electronic components.The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using optimized SW routines with a performance up to 25KBaud in Slave Mode with half duplex transmission and an overhead less than 60% atSAB C513 with 12 MHz. Due to the implementation in C this performance is not the limitof the chip. A pure implementation in assembler will result in a strong reduction of theCPU load and therefore increase the maximum speed of the interface. In addition,microcontrollers like the SAB C505 will speed up the interface by a factor of two becauseof an optimized architecture compared with the SAB C513.Moreover, this solution lays stress on using as few on-chip hardware resources aspossible. A more excessive consumption of those resources will result in a highermaximum speed of the emulated interface.Due to the restricted performance of an 8 bit microcontroller a pin compatible solution isprovided only; the internal register based programming interface is replaced by a set ofsubroutine calls.The attached source files also contain a test shell, which demonstrates how to exchangeinformation between an on-chip HW-SSC and the emulated SW-SSC via 5 external wiresin different operation modes. It is based on the SAB C513 (Siemens 8 bit microcontroller).A table with load measurements is presented to give an Indication for the fraction of CPUperformance required by software for emulating the SSC.
标签： synchronous Emulating serial
上传时间： 2014-01-31
上传用户：z1191176801
提出了一种基于PIC16F877A微控制器和CC2500射频收发器芯片的低功耗、低成本RFID（Radio Frequency Identification， 无线射频识别）局域定位系统设计方法，介绍了系统的定位工作原理、主要硬件电路模块及定位算法的设计和实现。采用基于序列号对时隙数运算的排序算法有效解决了多标签识别碰撞的问题，基于射频辐射强度（Received Signal Strength Indication， RSSI）和圆周定位算法实现了基于RFID多标签系统的平面定位。实验测试表明，这种射频定位方法能够实现一定精度下的无线局域定位的功能。
上传时间： 2013-11-06
上传用户：weareno2
This paper presents a new adaptive mobility-aware MAC protocol for sensor networks (MS-MAC). The protocol uses any change in received signal level as an Indication of mobility and, when necessary, triggers the mobility handling mechanism. By doing this way, the new mobility-aware MAC protocol can work very energy-efficiently when the network is stationary, whereas it can maintain some level of network performance when there are mobile sensors.
标签： mobility-aware adaptive networks presents
上传时间： 2014-01-11
上传用户：libenshu01
THIS PUBLICATION IS COPYRIGHT PROTECTEDCopyright © 2014 IEC, Geneva, SwitzerlandAll rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any formor by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing fromeither IEC or IEC's member National Committee in the country of the requester. If you have any questions about IECcopyright or have an enquiry about obtaining additional rights to this publication, please contact the address below oryour local IEC member National Committee for further information.Droits de reproduction réservés. Sauf Indication contraire, aucune partie de cette publication ne peut être reproduiteni utilisée sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopieet les microfilms, sans l'accord écrit de l'IEC ou du Comité national de l'IEC du pays du demandeur. Si vous avez desquestions sur le copyright de l'IEC ou si vous désirez obtenir des droits supplémentaires sur cette publication, utilisezles coordonnées ci-après ou contactez le Comité national de l'IEC de votre pays de résidence.
标签： iec标准
上传时间： 2021-10-21
上传用户：kent
